Rally Stripe Decal Kit for Subaru WRX | subaru decals

Description

A dual rally stripe decal kit sized for the Subaru WRX, printed on Cast Vinyl for a clean, painted-on look. Made for owners who want classic motorsport striping without permanent paint work.

Classic Dual Stripe Stying for Your WRX

This rally stripe decal kit brings the look of vintage motorsport striping to your Subaru WRX. Two parallel stripes run the length of the vehicle, echoing the livery style made famous on rally stages decades ago. The kit is cut to work with the WRX body lines, so the stripes flow naturally over the hood, roof and trunk. Whether you drive a sedan or a wagon, the striping adds a performance-inspired accent that reads as intentional rather than aftermarket. It is a simple way to change the character of the car without touching the paint, and it can be removed cleanly when you are ready for a different look. Part of our subaru decals collection.

Choose Your Finish and Size

Every kit is printed to order in your choice of matte, gloss, clear or static cling finish. Matte gives a low-key, flat look that photographs well; gloss reads closest to fresh paint; clear works over factory colors for a subtle tone-on-tone effect; static cling applies without adhesive for temporary use. Sizes run 4, 8, 12 or 18 inches, measured per stripe, so you can go slim and subtle or wide and bold. A 4-inch pair sits neatly within the hood centerline, while 18-inch stripes make a strong statement across the full body. Pick the combination that matches how loud you want the car to speak.

How the Kit Goes On

Application is a wet or dry process using the included transfer film. Clean the paint with isopropyl alcohol, position the stripes with light masking tape as a hinge, peel the backing and squeegee from the center outward. The Cast Vinyl conforms to gentle curves and body seams, and a little heat from a hair dryer helps it settle around edges. On a WRX, most installers start at the hood leading edge and work rearward so the stripes stay aligned through the windshield pillars. Take your time on alignment, since the two-stripe layout is only as good as its symmetry. Full instructions ship with every kit.

Removal and Everyday Care

When you want the stripes off, warm them with a hair dryer and peel slowly at a shallow angle; the adhesive releases without leaving residue on well-maintained paint. Wash the car as usual, avoiding high-pressure sprayers pointed directly at stripe edges. Avoid automatic brush washes, as brushes can lift corners over time. If a section ever lifts, a touch of heat and firm pressure usually resets it. Because the vinyl is printed in our rather than sourced as pre-cut rolls, each kit is checked before it ships, and replacement sections are available if a stripe is damaged during installation.

What you get

• Dual rally stripe layout cut to complement Subaru WRX body lines
• Available in 4, 8, 12 or 18 inch stripe widths
• Choose matte, gloss, clear or static cling finish
• Printed on Cast Vinyl that conforms to curves and contours
• Wet or dry application with transfer film included
• Removable without residue on well-maintained paint
• Printed to order in our US

Specifications

Frequently asked questions

Will these stripes fit my WRX?

The kit is sized for the Subaru WRX body, but stripe width is a style choice, not a fitment spec. Measure the area you want covered and choose the 4, 8, 12 or 18 inch option that suits it. Not affiliated with or endorsed by the manufacturer.

Can I install the kit myself?

Yes. The kit ships with transfer film and step-by-step instructions. The main challenge is keeping the two stripes parallel, so take time aligning with masking tape before committing to the squeegee pass.

Which finish should I pick?

Gloss matches painted bodywork most closely, matte gives a flat motorsport look, clear creates a subtle effect over your factory color, and static cling is best if you only want the stripes on temporarily.