By vehicle
By style
By position
Guides
Marine & water
Powersports
Storefront & office
Labels & packaging
Bulk & wholesale
Send your own artwork
Upload your logo or sketch on any product page: we cut it in the width you choose.
Shop
Kids & anime
Sports & fan
Custom stickers
Start here
Your design, our vinyl
Send a sketch or logo, optional upload box sits under the size selector on every product.
Finishes we print
Sizes we cut
12"18"24"36"48"
A pair of gloss outline side decals cut from Cast Vinyl, sized for crossover EV doors and quarter panels. Made for owners who want a clean accent line without permanent paint work.
JPG, PNG, WEBP or PDF, up to 20 MB. Leave this empty to order the design shown above.
This listing is for a matched pair of outline side decals with a gloss finish, cut to follow the lower body line of a crossover EV. Choose 4, 8, 12 or 18 inches per side depending on how much coverage you want: the 4 and 8 inch cuts work as small accents near the front door, while the 12 and 18 inch cuts stretch across the door and into the rear quarter panel. Each decal is weeded by hand and shipped with application tape so the outline lifts off the backing in one piece. Because it is a pair, you can dress both sides of the vehicle in a single session without cutting or trimming to match.
We print and cut these outlines on gloss Cast Vinyl, which lays down flat and follows gentle body curves without lifting at the edges. The gloss surface catches light the same way clearcoat does, so the line blends into the panel instead of sitting on top of it like a sticker. Cast Vinyl is thinner and more conformable than calendered vinyl, which is why we use it for anything that has to wrap around a door crease or wheel arch. The adhesive is pressure-sensitive: once you squeegee it down and pull the transfer tape, it stays put through washes and weather, and it can still be peeled off later without scraping.
Start with a clean, dry, wax-free panel and a temperature between roughly 60 and 80 degrees Fahrenheit. Position each decal with small strips of tape as a hinge, confirm the line sits parallel to the body crease, then peel the backing away and squeegee from the center outward. Work slowly on the curves and let the vinyl relax into them rather than stretching it. Pull the application tape back at a low angle against itself, not straight up. Keep the car dry for the first 24 hours so the adhesive fully bonds. Every order includes printed instructions, and a plastic squeegee makes the job easier if you have one handy.
A lot of people land on our site after hunting down game builds, then realize we also cut real-world vinyl for actual cars. If that is you, welcome: this outline pair is one of our most straightforward installs, and it is a good first project if you have never applied vinyl before. The 4 inch size is a low-commitment way to test placement before committing to a longer line, and the finish options we stock include matte, gloss, static cling and clear, so you can coordinate this pair with other accents you already own. Questions about sizing or finish? Message us before ordering and we will help you pick.
The 4 and 8 inch cuts work as short accents near the front door. The 12 and 18 inch cuts run longer along the body line and reach toward the rear quarter panel. Measure your panel first, since door lengths vary between vehicles.
Applied to factory paint in good condition, the adhesive removes cleanly when peeled slowly. Avoid applying over fresh paint, repainted panels, or damaged clearcoat, and avoid using a heat gun on removal.
Yes. We also cut this design in matte and clear vinyl, and static cling is available if you want a temporary, non-adhesive option. Message us before ordering so we can set up the finish you want.
Not affiliated with or endorsed by the manufacturer. It is an independent aftermarket Vinyl Decal.
4 inch, 8 inch, 12 inch, 18 inch
Your shopping cart is empty
Notifications
