By vehicle
By style
By position
Guides
Marine & water
Powersports
Storefront & office
Labels & packaging
Bulk & wholesale
Send your own artwork
Upload your logo or sketch on any product page: we cut it in the width you choose.
Shop
Kids & anime
Sports & fan
Custom stickers
Start here
Your design, our vinyl
Send a sketch or logo, optional upload box sits under the size selector on every product.
Finishes we print
Sizes we cut
12"18"24"36"48"
A set of four vinyl ring decals sized to frame your electric SUV's charging port. Made for owners who want a clean accent around the charge door without adhesive mess or permanent changes.
JPG, PNG, WEBP or PDF, up to 20 MB. Leave this empty to order the design shown above.
The charge port is one of the most touched spots on an electric vehicle. You plug in daily, and that small door ends up being the focal point of the rear quarter every time you walk up to the car. A ring decal frames that area and gives it a finished, deliberate look instead of a plain factory panel. This pack includes four identical rings, so you can dress the port on more than one vehicle in the household, keep spares for a future reposition, or share a set with another EV owner. Each ring is cut from a single piece of vinyl with a clean inner and outer edge, so there are no seams or layered edges to catch on the charge cable.
Every ring in this pack is printed in one of our four available finishes. Matte sits flat against the paint and reads as a subtle, understated accent that blends with darker body colors. Gloss catches light and gives the ring a slightly raised, polished look. Static cling uses no adhesive at all, so it holds by surface tension and peels off without residue, which suits leased vehicles or anyone who likes to swap styles. Clear vinyl works well over lighter paint or as a protective barrier around the port itself. Choose the finish and size that matches how visible you want the ring to be on your Model X.
This decal pack is offered in four ring sizes: 4, 8, 12, and 18 inches. The smaller sizes sit close to the port opening and create a thin outline effect, while the larger sizes frame the whole charge door panel for a bolder statement. Before ordering, measure the flat area around your port with a tape measure to confirm which diameter fits without wrapping onto body curves or trim gaps. Vinyl applies best to smooth, flat surfaces, so pick the size that keeps the full ring on the same panel. If you are between two sizes, the smaller option is usually the safer fit.
Application takes a few minutes with household items. Wash the area around the charge port with mild soap and water, then dry it completely so no dust sits under the vinyl. Peel the paper backing, align the ring over the port, and press from the center outward to push air toward the edges. A plastic card wrapped in a soft cloth helps smooth the ring down without scratching the vinyl. Avoid applying in freezing temperatures or direct hot sunlight, since extreme cold and heat both make vinyl harder to position. Wait a day before running the area through a pressure wash, and hand wash around the ring normally afterward.
No. The ring frames the outside of the port area and does not cover the door seam or latch mechanism. Apply it to the flat panel surrounding the port so the door can open and close normally.
Yes. Warm the vinyl slightly with a hair dryer on low and peel it back slowly at a shallow angle. Any remaining adhesive wipes away with a mild adhesive remover. The static cling version peels off by hand with no residue at all.
Measure the flat surface around your charge port first. A 4 or 8 inch ring outlines just the port opening, while 12 and 18 inch rings frame the full panel. Keep the entire ring on one flat surface for the best appearance and adhesion.
Not affiliated with or endorsed by the manufacturer. It is an independent aftermarket Vinyl Decal.
4 inch, 8 inch, 12 inch, 18 inch
Your shopping cart is empty
Notifications
