By vehicle
By style
By position
Guides
Marine & water
Powersports
Storefront & office
Labels & packaging
Bulk & wholesale
Send your own artwork
Upload your logo or sketch on any product page: we cut it in the width you choose.
Shop
Kids & anime
Sports & fan
Custom stickers
Start here
Your design, our vinyl
Send a sketch or logo, optional upload box sits under the size selector on every product.
Finishes we print
Sizes we cut
12"18"24"36"48"
A pair of gloss-finish rally stripe decals cut from Cast Vinyl, sized for hoods, trunks and side panels of Subaru cars. For owners who want classic motorsport striping without paint.
JPG, PNG, WEBP or PDF, up to 20 MB. Leave this empty to order the design shown above.
This Subaru decal kit brings the look of vintage rally striping to your daily driver or weekend build. Two parallel stripes run the length of your chosen panel, echoing the livery style made famous on gravel stages and circuit paddocks. Each kit is cut to the width you select, so you can scale the stripes for a full hood run, a short trunk accent, or a pair of side skirts. The clean gloss surface catches light the way painted stripes do, at a fraction of the cost and commitment. Apply it to a WRX, Impreza, BRZ, Forester or any Subaru model with flat or gently curved body panels. Not affiliated with or endorsed by the manufacturer.
We print and cut these stripes from Cast Vinyl with a high-gloss finish, chosen because it sits flat and conforms to the gentle curves of a hood or trunk lid without lifting at the edges. The gloss surface reflects light evenly, so the stripes read as painted-on rather than stuck-on from a distance. Cast Vinyl is thinner and more flexible than calendered vinyl, which is why we use it for automotive applications where the material has to follow body lines. The stripes arrive pre-masked with transfer tape, so the pair stays perfectly parallel while you position it on the vehicle. One alignment edge keeps your spacing consistent from front to back.
Every kit is offered in four decal sizes: 4, 8, 12 or 18 inches, measured across the full width of the stripe pair. The 4-inch size suits mirror caps, fender accents or a subtle trunk detail. The 8-inch option works well on rear quarter panels or a partial hood stripe. The 12-inch size covers a full hood or trunk on most sedans and coupes. The 18-inch width is built for broad hoods, roof runs or truck-bed applications. Measure the panel you plan to stripe before ordering, and remember the pair needs clear space on both sides for a balanced look. Each size ships as a matched left-and-right set.
Installation takes patience but no special tools. Wash the panel and remove any wax with isopropyl alcohol, then let the surface dry completely. Warm the decal slightly with a hair dryer on cool days so the vinyl relaxes into curves. Peel the backing paper, position the pre-masked pair using the alignment edge, and squeegee from the center outward to push air toward the edges. Slowly peel the transfer tape back on itself at a low angle. Park in shade for the first day while the adhesive sets. If you reposition during installation, lift gently and re-apply before pressing down fully. Full step-by-step instructions ship with every kit.
The kit is not model-specific, so it works on any Subaru with a flat or gently curved panel large enough for the stripe width you choose. Measure your hood, trunk or side panel before ordering and compare it to the 4, 8, 12 or 18 inch decal sizes.
Yes. Warm the vinyl with a hair dryer and peel it back slowly at a low angle. Any remaining adhesive can be cleaned off with isopropyl alcohol. Removal is easiest when the panel is warm.
Small bubbles can be pushed out with the squeegee working from the center outward. If a bubble remains, pierce it with a pin and smooth the air out. Warming the vinyl slightly helps it conform around curves.
4 inch, 8 inch, 12 inch, 18 inch
Your shopping cart is empty
Notifications
