By vehicle
By style
By position
Guides
Marine & water
Powersports
Storefront & office
Labels & packaging
Bulk & wholesale
Send your own artwork
Upload your logo or sketch on any product page: we cut it in the width you choose.
Shop
Kids & anime
Sports & fan
Custom stickers
Start here
Your design, our vinyl
Send a sketch or logo, optional upload box sits under the size selector on every product.
Finishes we print
Sizes we cut
12"18"24"36"48"
A pair of matte Cast Vinyl side stripe decals sized for the Model S body line. Made for owners who want a clean racing-stripe look without paint or permanent bodywork.
JPG, PNG, WEBP or PDF, up to 20 MB. Leave this empty to order the design shown above.
This decal pair brings a classic dual racing stripe to the flanks of a Model S. Each stripe is cut from matte Cast Vinyl, so the finish reads as a flat, painted-on accent rather than a shiny sticker sitting on top of your clear coat. The set includes one stripe for each side of the car, matched in length so the car looks symmetrical when you step back. Choose 4, 8, 12 or 18 inch stripe lengths depending on how subtle or bold you want the accent to be. Shorter sizes sit nicely along the front fender, while longer sizes can trail down the door line. Application is a dry, peel-and-place process you can do in a driveway.
Matte vinyl has become a favorite for model car decals because it disappears into the surface it sits on. There is no gloss to catch sunlight and reveal the edge of the film, which matters on large flat panels and curved door sections. The stripes are contour-cut with clean edges, so there is no clear carrier film border left behind after install. Cast Vinyl is thin and conformable, meaning it lays down over gentle body curves without tenting or lifting at the corners. Once applied, the stripes read as part of the car's design language rather than an add-on. If you ever want to remove them, warm vinyl peels away without leaving residue behind.
The four available sizes cover different styling goals. A 4 inch pair works as a small accent near the fender vent or mirror line, a subtle nod to motorsport livery. The 8 inch size is a middle ground that suits the front door section. A 12 inch pair extends the visual line further down the car and balances well against the wheelbase. The 18 inch option makes the boldest statement, running a long stripe down the side profile. Before ordering, measure the panel area you plan to cover and compare it to the listed decal size. Sizing the stripe to your intended placement is the single biggest factor in how finished the result looks.
Start with a clean, dry, wax-free panel. Position each stripe with light tack first, confirm alignment against body lines, then press down from the center outward with a felt-edge squeegee or soft card. Work in moderate temperatures and out of direct sun so the vinyl behaves predictably. After install, avoid pressure washing directly at the stripe edges for the first day or two. For ongoing care, hand wash as usual and skip abrasive waxes or polishes on the striped area. If a corner ever lifts, gentle heat from a hair dryer softens the adhesive so you can press it back down. Removal follows the same idea: warm the vinyl and peel slowly.
The stripes are cut as a universal pair rather than a body-specific template, so they work across Model S generations. Measure your intended placement area and compare it to the 4, 8, 12 or 18 inch decal sizes before ordering.
Yes. Lightly tack the stripe in place, check its alignment against your body lines, and lift to adjust before final squeegeeing. Once firmly pressed down, avoid pulling the vinyl back up.
Matte vinyl has a flat sheen, so it reads as a deliberate contrast accent on gloss paint and blends more closely on matte or Low-Gloss paint. It is not a paint match, it is a styling stripe.
Not affiliated with or endorsed by the manufacturer. It is an independent aftermarket Vinyl Decal.
4 inch, 8 inch, 12 inch, 18 inch
Your shopping cart is empty
Notifications
