By vehicle
By style
By position
Guides
Marine & water
Powersports
Storefront & office
Labels & packaging
Bulk & wholesale
Send your own artwork
Upload your logo or sketch on any product page: we cut it in the width you choose.
Shop
Kids & anime
Sports & fan
Custom stickers
Start here
Your design, our vinyl
Send a sketch or logo, optional upload box sits under the size selector on every product.
Finishes we print
Sizes we cut
12"18"24"36"48"
Matte trail-rated side panel decals cut for Jeep Wrangler doors and body panels. Sold as a mirrored set in your choice of width from 12 to 48 inches.
JPG, PNG, WEBP or PDF, up to 20 MB. Leave this empty to order the design shown above.
These Off-Road side panel decals are cut and sold as a mirrored pair, sized to work with Jeep Wrangler doors and rear quarter panels. Whether you run a two-door or four-door, you can pick the width that fits your build, from a subtle 12-inch accent to a full 48-inch panel graphic. The lettering and trail-rated styling give your rig an off-road look without the cost of a full wrap. Each decal is printed on cast vinyl with a matte finish, so it reads like a factory-applied graphic instead of a shiny sticker. Not affiliated with or endorsed by the manufacturer.
Every set is made to order in the width you select at checkout. A 12-inch pair works well as a small accent near the door handle or rear fender, while 24- and 30-inch widths are popular choices for the lower door panels. If you want maximum coverage across the doors and quarter panels, the 36- and 48-inch options fill the space edge to edge. Because the decals are cut as a matched left and right pair, you get a balanced look on both sides of the vehicle. Measure your panel area before ordering so the width you choose clears handles, hinges, and body lines.
We print these side decals on cast vinyl with a matte finish. Cast vinyl conforms to gentle curves and body lines, so the decal lays flat without lifting at the edges. The matte surface cuts glare in photos and matches the flat look many Jeep Wrangler owners prefer over a gloss sticker. Application is a dry or wet install with transfer tape: clean the panel, position the decal, squeegee from the center out, and peel the carrier. The vinyl removes cleanly with heat when you are ready for a change, without leaving adhesive behind on factory paint.
Each order arrives as a left and right decal set on transfer tape, sandwiched between a release liner and a protective top layer, rolled in a rigid mailer so it reaches you flat. Before installing, wash the panel and remove any wax or residue with isopropyl alcohol. Work in shade when the panel surface is cool to the touch. Install one side at a time, using the body line as a guide to keep the pair level. Once the transfer tape is peeled, the decal is wash-safe by hand; avoid pressure washers aimed directly at the edges. Explore our full Jeep Wrangler decals collection for matching hood and rear graphics.
Yes. Because you choose the width from 12 to 48 inches, you can size the pair to fit either body style. Measure your door and quarter panel area before ordering to confirm clearance around handles and hinges.
The matte finish is low-gloss and pairs well with flat or low-gloss paint tones. On gloss paint it will read as a flat graphic, which is the intended trail-rated look.
Warm the decal with a heat gun or hair dryer on low and peel slowly at a shallow angle. Any remaining adhesive can be rolled off with your fingers or removed with adhesive remover.
12", 18", 24", 36", 48"
Your shopping cart is empty
Notifications
