Slicer Stripes Semi Truck Decals | Custom Car Decals

Description

Slicer stripe vinyl graphics cut to your chosen width from 12 to 48 inches, made for semi truck owners who want a sharp, layered look on their cab or sleeper. Sold as a complete set.

What Comes in a Slicer Stripes Truck Decal Set

Each set includes the full stack of angled stripe pieces you need to dress both sides of your rig, pre-cut and ready to apply one section at a time. You pick the overall width, from 12 inches up to 48 inches, so the same design can run subtle on a day cab or bold across a long sleeper. The stripes arrive on release paper with application tape over the face, which keeps the spacing between each slice exactly as it was cut. That means no measuring and cutting individual stripes yourself on a shop floor. Everything is trimmed with clean edges so the layered slicer look lines up the way it should once the last piece is pressed down.

How These Custom Car Decals Are Printed and Cut

We produce every slicer stripe set to order in our shop using cast vinyl, cut on a plotter from your chosen width and colorway. Cast vinyl is the thin, conformable option that follows the slight texture and curves of cab panels without lifting at the edges, and it holds its color through sun, road spray, and repeated washings. You can order the set in a matte finish for a low-key, painted-on look, a gloss finish for extra pop against factory paint, or clear for a subtle tone-on-tone effect. Because each set is cut after you order, the stripes are fresh stock, not something that has sat in a warehouse losing tack.

Applying Slicer Stripes to a Semi Truck Cab or Sleeper

Start with a clean, dry, wax-free surface; a wipe-down with isopropyl alcohol removes the road film that keeps vinyl from biting. Warm the panel slightly if you are working in a cold bay or outdoors in winter. Position the first stripe section with the application tape still on, check the angle against your body lines, then squeegee from the center outward to push out air. Peel the tape slowly at a shallow angle. Overlap each following slice slightly at the seam so weather cannot work its way under an edge. Two people make the wider 36 and 48 inch sets easier to handle, but a solo install is doable with patience.

Choosing Your Stripe Width and Finish

Width comes down to how much real estate you want the stripes to cover. A 12 or 18 inch set sits tight along the lower body line and reads as an accent. Twenty-four and 30 inch widths fill the space between the rocker and the door handle height, which is the most common choice among drivers we hear from. The 36 and 48 inch sets make the slicer angles the main event on the side of the truck. On finish, matte softens the graphic into the paint, gloss gives the strongest contrast in photos at truck shows, and clear works when you want the shape without much added color.

What you get

• Sold as a complete slicer stripes set sized to your truck
• Choose overall widths from 12 inches to 48 inches
• Printed and cut to order on cast vinyl in our US shop
• Available in matte, gloss, clear, and static cling finishes
• Pre-spaced on application tape for straightforward install
• Works on cabs, sleepers, and trailer panels
• Custom colorways available on request

Specifications

Frequently asked questions

Do these stripes fit my specific cab model?

The sets are cut by width rather than to a specific cab profile, so measure the flat panel area you want to cover and order the width that fits. The cast vinyl conforms to gentle curves and body lines.

Can I get a custom color for my slicer stripes?

Yes. Along with the standard colorways, we can cut sets in custom colors and finish combinations. Contact us with your color preference and the width you need before ordering.

What if I only want stripes on one side of the truck?

The set is priced for both sides, but you can apply just one side and keep the remaining pieces as spares for future repairs after road damage.