Skull Link Boat Decals - Cast Vinyl Marine Graphics

Description

A linked skull graphic set printed on cast vinyl for boats, offered in widths from 12 to 48 inches. Made for boaters who want bold marine graphics that hold up to sun and spray.

Linked Skull Design for Your Hull

This set pairs repeating skull shapes into a continuous chain graphic that runs along your hull, gunwale, or transom. The connected pattern creates a strong visual line that draws the eye from bow to stern, whether you place it above the waterline or along the rub rail. Each skull links cleanly to the next, so the design reads as one unbroken element rather than separate stickers. Choose a matte finish for a low-sheen, painted-on look, gloss for a bold shine that pops against gelcoat, or clear vinyl if you want the graphic to sit subtly over your existing hull color. Sizes range from 12 to 48 inches wide, so the set can work on anything from a small skiff to a larger offshore rig.

Marine-Grade Vinyl Built for the Water

These boat decals are printed on cast vinyl, a thin, flexible film that conforms to the curves of a hull without lifting at the edges. Cast vinyl is the same film type marine graphics shops rely on for hull striping and lettering because it stretches around contours and resists the cracking that thicker films can show after repeated sun exposure. We print with printed inks and laminate the graphic to help protect against salt spray, fuel splashes, and wash-down scrubbing. Apply it to clean gelcoat, painted surfaces, or smooth fiberglass. Static cling is also available if you want a removable option for seasonal use or for testing placement before committing to a permanent spot.

Choosing Your Size and Placement

Measure the area where you plan to place the graphic before ordering, and compare that measurement to the listed width options. A 12-inch set suits small transoms, console sides, or cooler lids, while 24 to 36 inches works well along the sides of a center console or bay boat. The 48-inch width is sized for longer runs along hulls or for larger offshore vessels. When placing your order, note the width you want and we cut the linked skull chain to that dimension. For best results, apply above the waterline on a dry surface above 60 degrees Fahrenheit, and let the decal cure for a day or two before launching to help the adhesive bond fully.

Application and Care

Every set ships with the decal masked with application tape, so you position the whole chain in one piece rather than lining up individual skulls. Clean the surface with isopropyl alcohol and let it dry completely, then peel the backing, position one end, and squeegee from the center outward to push out air. Slowly remove the transfer tape, leaving the graphic on the hull. After application, wash with mild soap and water or a boat soap and a soft cloth. Avoid high-pressure spray directly at the edges of the decal. If you chose static cling, the surface needs no adhesive cure time, and you can reposition or remove it without residue at the end of the season.

What you get

• Set of linked skull graphics printed as one continuous chain
• Available in 12, 24, 36, and 48 inch widths
• Printed on flexible cast vinyl that conforms to hull curves
• Choose matte, gloss, clear, or static cling finish
• printed inks with a protective laminate layer
• Ships with application tape for one-piece installation
• Cut and packed to order in our US shop

Specifications

Frequently asked questions

Can these decals go below the waterline?

We recommend applying them above the waterline. Constant submersion, marine growth, and antifouling paint can affect adhesion and print quality over time.

Will the decal damage my gelcoat when I remove it?

Applied to intact gelcoat or paint, the decal should remove cleanly when warmed gently with a hair dryer and peeled at a low angle. Static cling removes with no adhesive at all.

How do I know which width to order?

Measure the length of the flat area where you want the chain to run and compare it to the width options. If you are between sizes, choose the smaller width so the graphic fits without wrapping around curves or hardware.