Ripper Marshland Camo Truck Graphics Decal Set

Description

A marshland camo decal set for trucks and cars, printed on cast vinyl in your choice of width from 12 to 48 inches. For drivers who want a custom car decals look with a bold hunting-inspired pattern.

Marshland Camo Truck Graphics Built for the Outdoors

The Ripper Marshland set brings a layered wetland camo pattern to your truck or car in a clean die-cut layout. Each piece is cut from cast vinyl so the graphics sit flat against doors, tailgates, toolboxes, or bed panels without heavy edges that trap dirt. The design reads as one continuous pattern across the panels, giving the look of a full custom wrap without the installation time or cost. Choose the width that fits your build, from a subtle 12-inch accent to a full 48-inch statement across the side of a pickup. Whether you run a hunting rig, an off-road trail truck, or just want custom car decals that stand out at the boat ramp, this set is made for vehicles that spend time outside.

Choose Your Width and Placement

Every set is offered in four width options: 12, 24, 36, and 48 inches. The 12-inch size works well on tailgates, rear windows, and toolboxes. The 24-inch option suits single cab doors or the lower bed panel on a midsize truck. At 36 inches, the pattern covers a full door or a wide section of a bed side. The 48-inch set is sized for extended cab and full-size trucks where you want the camo to run the length of the panel. Measure the flat area you plan to apply before ordering, and keep in mind body lines, handles, and fuel doors. The pieces are designed to be trimmed during install if you need to work around hardware.

Matte, Gloss, and Clear Finish Options

Pick the finish that matches your vehicle. Matte gives the camo a flat, painted-on look popular with hunting and off-road builds. Gloss adds depth and shine that pairs well with clean paint. Clear finish is available for glass and smooth surfaces where you want the pattern without a visible background. All three options use the same printed marshland artwork, so the choice is purely about the surface and the look you want. Matte is the most common pick for truck graphics because it blends with flat paint and bedliner textures, while gloss tends to stand out more on daily drivers and show builds.

Applying Your Camo Decal Set

Application works best on a clean, dry surface above roughly 60 degrees Fahrenheit. Wash the area, remove wax with isopropyl alcohol, and let it dry fully. Peel the backing, position the decal using the transfer tape, and press from the center outward with a squeegee or credit card. Work slowly to push air toward the edges, then remove the transfer tape at a low angle. Avoid washing the vehicle for the first few days so the adhesive bonds fully. Each set ships with application instructions, and the process is the same whether you are placing one large panel piece or several smaller accents around the truck.

What you get

• Marshland camo pattern printed on cast vinyl
• Available in 12, 24, 36, and 48 inch widths
• Choose matte, gloss, or clear finish
• Die-cut pieces for doors, tailgates, and bed panels
• For trucks, SUVs, and cars
• Ships with application instructions
• Can be trimmed during install to fit around hardware

Specifications

Frequently asked questions

Will one set cover both sides of my truck?

Coverage depends on the width you choose and the panels you are applying it to. The larger widths cover more area per piece, but a full both-sides treatment on a full-size truck may require two sets. Measure your panels before ordering.

Can I remove the decals later?

Yes. Warm the decal with a hair dryer or heat gun on low and peel slowly. Any remaining adhesive can be cleaned off with isopropyl alcohol. Removal is easiest when the surface is warm.

Which finish should I pick for a hunting truck?

Matte is the most popular choice for hunting and off-road builds because it has no shine and blends with flat paint and textured surfaces. Gloss works well if you want the pattern to stand out.