Dragon Skeleton Boat Decals Set of 2 | Marine Vinyl

Description

A set of two dragon skeleton decals cut from marine-grade cast vinyl, made for boat owners who want a bold, detailed graphic on the hull or transom. Available in widths from 12 to 48 inches with matte, gloss, clear or static cling finishes.

A Dragon Skeleton Boat Decal Set Built for the Water

This two-piece dragon skeleton design gives your boat a striking, weathered-bone look that stands out at the dock and on the water. Each decal is cut from cast vinyl, a thin, conformable material that follows the gentle curves of a hull without lifting at the edges. The set ships as a mirrored pair, so you can run the design down both sides of the boat, split it between the hull and transom, or use one on the boat and keep the second for a trailer or tow vehicle. Choose a width from 12 to 48 inches to match your available space, from a small skiff to a larger cruiser.

Cast Vinyl That Holds Up to Marine Use

Boats live a hard life: sun, spray, salt and trailering down the highway. That is why we cut these dragon skeleton decals from cast vinyl rather than calendered stock. Cast vinyl is thinner and more flexible, so it lays flat over rivets, seams and slight hull contours. The inks and material are chosen for outdoor use on watercraft. We never promise a fixed lifespan, but this is the same vinyl family we use across our boat decals collection, and it is made to be installed once and enjoyed for as long as it lasts.

Four Finishes and How to Pick Yours

Every set is offered in matte, gloss, clear and static cling. Matte is the low-glare choice that reads cleanly in bright sun and pairs well with darker hulls. Gloss adds depth and shine that pops against flat or fiberglass-white surfaces. Clear lets the dragon skeleton appear to float directly on your hull color, with the graphic printed on transparent film. Static cling uses no adhesive at all; it grips with static charge, so it is ideal for windows, hatches or anyone who wants a removable option for seasonal use. All four options are cut and printed in our US shop to your chosen size.

Installing Your Dragon Skeleton Decals

Application takes a few minutes with basic tools. Clean the hull with isopropyl alcohol and let it dry completely, since wax, salt film and release agents are the most common causes of edge lift. Position each decal with masking tape as a hinge, peel the backing, and squeegee from the center outward to push air out to the edges. Warm water with a drop of dish soap can be used for a wet application if you want extra time to align the mirrored pair. Wait 24 to 48 hours before launching so the adhesive fully bonds. Full step-by-step instructions are included with every set.

What you get

• Set of 2 mirrored dragon skeleton decals for symmetrical hull placement
• Cut from marine-grade cast vinyl for flexibility and outdoor durability
• Available in 12", 18", 24", 36" and 48" widths
• Choose matte, gloss, clear or static cling finish
• Printed and cut to order in our US shop
• Detailed skeleton artwork with clean, precise die-cut edges
• Application instructions included with every set

Specifications

Frequently asked questions

Are the two decals in the set identical?

They are mirrored images of each other, so when you apply one to each side of the boat, the dragon skeletons face the same direction and look symmetrical. You can also install them both facing the same way if you prefer.

What size should I choose for my boat?

Measure the flat, unobstructed area where you plan to place the decal before ordering. The listed width is the overall width of the design, so allow a little extra margin around hatches, rub rails and hardware. The 24 to 36 inch widths are popular on center consoles and bow sections.

Can I remove the decal later?

Yes. Warm the decal with a hair dryer or heat gun on low and peel it away slowly at a shallow angle. Any remaining adhesive can be cleaned off with isopropyl alcohol. The static cling option peels off with no residue at all and can be repositioned.