Gloss Hood Stripe Decal for Model S | 4-18 Inch

Description

A gloss vinyl hood stripe decal cut to dress up a Tesla Model S. Choose from 4, 8, 12 or 18 inch sizes to get the stripe width that fits your build.

A Center Stripe That Fits Your Model S

This gloss hood stripe is cut from Cast Vinyl and sized to run down the center line of a Model S hood. It ships in four decal sizes, 4, 8, 12 or 18 inches, so you can pick a slim accent line or a wide racing stripe depending on the look you want. The gloss finish sits close to a freshly waxed paint surface, which helps the stripe blend in rather than read as an add-on. Each stripe is cut to order in our, trimmed with a small margin so you can position it by hand without fighting the material. If you are browsing model car decals for a daily driver, this is one of the easiest ways to change the front end without touching the paint underneath.

Gloss Vinyl Built for Outdoor Use

We print and cut this stripe on Cast Vinyl with a gloss laminate surface, the same material family we use for our outdoor-rated decals. Cast Vinyl conforms to the gentle curves of a hood without lifting at the edges, and the gloss top layer resists sun fading and car wash brushes better than plain printed vinyl. Application is a wet or dry install with transfer tape: spray, position, squeegee, then pull the tape. The vinyl removes cleanly with heat when you are ready for a change, without leaving adhesive residue behind. No drilling, no trimming on the car, and no permanent commitment to one look.

How to Choose Your Stripe Size

Size here means the width of the stripe, not the length. A 4 inch stripe reads as a thin accent line, popular with owners who want a subtle hint of contrast. The 8 inch size is our middle-ground pick and works well if your hood has body lines you want the stripe to sit between. A 12 inch stripe makes a clear statement, and the 18 inch option covers most of the hood width for a full racing look. If you are torn between two sizes, measure your hood between the outer body lines first and compare it to the sizes above before ordering.

Made to Order in Our

Every stripe is cut after you order, so it has not been sitting in a warehouse losing tack. We inspect each piece before it ships and pack it with a paper backing and transfer tape so it arrives flat and ready to apply. Orders include a link to our application guide with step-by-step photos, plus tips for aligning the stripe to the hood center. If the stripe arrives damaged or the cut is off, send us a photo and we will recut it. Shipping goes out from our US, typically within a couple of business days of your order.

What you get

• Cut from Cast Vinyl with a gloss finish
• Four decal sizes: 4, 8, 12 or 18 inch stripe width
• Wet or dry application with included transfer tape
• Removes with heat without leaving residue
• Cut to order in our US
• Fits the hood center line of a Tesla Model S

Specifications

Frequently asked questions

Will this stripe damage my paint?

No. The stripe applies over the existing clear coat and removes with a heat gun or hair dryer. On fresh or repainted panels, we suggest waiting about 30 days before applying any vinyl.

Which size should I pick for my Model S?

Measure the flat area of your hood between the outer body lines, then compare it to the 4, 8, 12 and 18 inch options. Most owners choose 8 or 12 inches for a balanced look.

Can I run this through a car wash?

Yes, once the stripe has fully cured, usually after about 48 hours. Hand washing is gentler on the edges, but touchless and soft-brush washes are fine for routine cleaning.

Is this an official brand product?

Not affiliated with or endorsed by the manufacturer. It is an independent aftermarket Vinyl Decal.