Jeep Windshield Decals Matte Vinyl Pair for Wrangler

Description

A pair of matte Cast Vinyl windshield decals sized for Jeep Wrangler-style glass. Made for drivers who want a clean, low-shine look on the trail or around town.

Matte Jeep Windshield Decals Built for the Top of Your Glass

This decal pair is cut from matte Cast Vinyl and sized to sit along the top edge of a windshield, one decal per side. The matte finish absorbs light instead of bouncing it back, so the graphics stay readable in bright sun and never flash glare across the glass the way a gloss decal can. Each decal is available in 4, 8, 12 or 18 inch widths, so you can run a subtle accent or a wide statement strip depending on the look you want. Apply them to the driver and passenger corners, center them as a matched pair, or trim them down for a custom fit on curved glass.

Cast Vinyl That Holds Up to Trail Dust and Highway Rain

We print these decals on Cast Vinyl, the conformable grade that bends around the slight curve at the top of a windshield without lifting at the edges. The matte surface resists water, mud splatter and bug hits, and it wipes clean with mild soap and water. Because the ink sits beneath the face film, washes and weather do not scrub the color away. Run them through automatic car washes or hand wash with a soft cloth and the decals keep their flat, low-sheen appearance. If you swap to a different rig later, warm the vinyl slightly and peel it away without aggressive scraping.

Easy Two-Decal Installation in Your Driveway

You do not need a appointment to install these. Clean the glass with isopropyl alcohol, let it dry, then position each decal with the transfer tape still in place. Use a squeegee or a credit card wrapped in a soft cloth to press from the center outward, pushing air toward the edges. Peel the tape slowly at a low angle and the decal stays behind. Working in shade or a garage keeps the glass cool and makes positioning easier. Most people finish both sides in under half an hour with no bubbles and no trimming required on flat sections.

Pick Your Width: 4, 8, 12 or 18 Inches

The 4 inch pair works as a slim accent near the visor line, while the 8 inch size is a popular middle ground for daily drivers. The 12 and 18 inch widths give you more visual weight and suit lifted builds, trail rigs and show Jeeps. Every pair ships as a matched left and right set on the same sheet, so the graphics line up evenly across both sides of the glass. If you are building out a full look, this pair pairs well with our other jeep windshield decals and body graphics in the same matte finish for a consistent, flat appearance across the whole vehicle.

What you get

• Sold as a matched pair, one decal for each side of the windshield
• Matte Cast Vinyl with a flat, low-glare finish
• Available in 4, 8, 12 or 18 inch decal widths
• Conforms to the curve at the top of windshield glass
• Printed with printed inks beneath the face film
• Applies with transfer tape, squeegee and isopropyl alcohol prep
• Removable with gentle heat without hard scraping

Specifications

Frequently asked questions

Will these decals fit my windshield?

The pair is cut in 4, 8, 12 or 18 inch widths, so measure the flat area of glass where you want them before ordering. The Cast Vinyl conforms to mild curves, and the decals can be trimmed during installation for a custom fit.

Can I still see out of the windshield with these installed?

Place the decals along the top edge of the glass, above your normal sightline. Check your local state regulations on windshield obstruction before installing anything in the driver's view area.

Are these safe for car washes?

Yes. Once the decals have fully adhered, usually after a few days, they hold up to automatic and hand washes. Avoid high-pressure spray directly at the decal edges during the first week.

Is this an official brand product?

Not affiliated with or endorsed by the manufacturer. It is an independent aftermarket Vinyl Decal.