Matte Black Racing Stripes for Corolla - Vinyl Decal Set

Description

A pair of matte black racing stripe decals cut from Cast Vinyl, sized for car owners who want a clean stripe look without paint. Choose 4, 8, 12 or 18 inch widths at checkout.

Matte Black Racing Stripes That Read as Paint, Not Sticker

The flat black finish is the whole point here. Gloss stripes catch light and announce themselves; matte absorbs it, so the lines sit low and quiet against your paint. On darker cars the contrast is subtle and layered, and on lighter cars the stripes read almost like a factory-applied accent band. Each stripe is cut from Cast Vinyl with a matte surface that holds its non-High-Visibility look across the full width of the decal. There is no sheen line at the edges and no printed texture to fade. If you have been browsing toyota racing stripes and keep finding shiny options that feel loud, this set is the understated alternative: two solid stripes, one finish, nothing extra.

Pick Your Width: 4, 8, 12 or 18 Inches

Stripe width changes the entire attitude of the car, so this set is sold by decal size rather than one fixed cut. The 4 inch pair sits narrow and sporty, closer to a classic motorsport accent. The 8 inch option is the balanced middle ground most drivers choose for a daily driver. The 12 inch pair fills the hood and roofline with real presence. The 18 inch set is the widest we offer and makes the boldest statement of the four. All sizes come as a matched pair so the spacing stays even from front to rear. Measure the panel you plan to cover before ordering, and remember the listed size refers to the decal width, not vehicle length.

Applying Your Stripe Pair Without Bubbles

Every set ships with transfer tape already applied, so the two stripes lift off the backing as one piece each and land on the car in position. Work on a clean, dry surface in mild weather, ideally out of direct sun. Peel the backing, tack one end of the stripe down, and use a squeegee or credit card to press the vinyl down progressively from center outward. The Cast Vinyl conforms to gentle panel curves, so take your time over body lines rather than stretching the material. Once the stripe is fully adhered, peel the transfer tape slowly back at a low angle. Small trapped air can be lifted with a pin and smoothed flat.

Care, Removal and Reordering

Matte vinyl is low maintenance: wash it with the same mild soap and water you use on the rest of the car, and skip waxes or polish directly on the stripe surface, since those products are formulated for gloss paint and can leave a visible sheen patch. Avoid high-pressure spray nozzles pointed straight at the stripe edges. When you eventually want the look gone, warm the vinyl gently with a hair dryer on low and peel it up slowly; the adhesive is designed to release cleanly from factory paint when removed with heat. If you want to try a different width later, the same set is available in all four sizes, and a gloss or clear finish version can be printed on request.

What you get

• Sold as a matched pair of two matte black racing stripe decals
• Available in 4, 8, 12 or 18 inch decal widths
• Cut from Cast Vinyl with a true non-High-Visibility matte surface
• Pre-masked with transfer tape for one-piece positioning
• Conforms to gentle panel curves without stretching
• Removes with gentle heat when you want a change
• Printed to order in our US

Specifications

Frequently asked questions

Will these stripes fit my specific car?

The set is sold by decal width, not by vehicle model, so fitment depends on where you place them and the panel space available. Measure the area you want to cover, such as hood width or roof width, and compare it to the 4, 8, 12 or 18 inch options before ordering.

Can I cut the stripes shorter to fit my panels?

Yes. The vinyl can be trimmed with a sharp hobby knife or scissors before application if you need a shorter run across a hood or trunk. Trim on the backing paper, then apply as usual with the transfer tape.

Is the matte finish available in other colors or finishes?

This listing is for matte black. If you would like the same stripe cut in gloss or clear vinyl instead, contact us before ordering and we can set up a custom order in your preferred width.

Is this an official brand product?

Not affiliated with or endorsed by the manufacturer. It is an independent aftermarket Vinyl Decal.