Matte Black Fender Flare Decals for Jeep Gladiator JT

Description

Matte black vinyl fender flare decal set cut to fit Jeep Gladiator JT flares. A clean way to add contrast over stock plastic without paint or drilling.

A Flat Black Overlay for Your Gladiator JT Fenders

The stock fender flares on a Jeep Gladiator JT come in textured plastic that can look washed out next to dark paint or armor. This decal set covers the flare faces with a matte black cast vinyl overlay, giving the wheel wells a deeper, uniform tone in an afternoon. Each piece is cut to follow the flare contours of the JT, so you are trimming guesswork out of the job. Whether your truck is a daily driver or a weekend trail rig, this is one of the simplest upgrades in our jeep gladiator decals collection. Not affiliated with or endorsed by the manufacturer.

Choose Your Width from 12 to 48 Inches

Every truck gets used differently, so this set is sold in a range of width options from 12 inches up to 48 inches. Narrower cuts keep the overlay tight to the flare edge for a subtle blackout look, while wider options extend coverage toward the body line for a more aggressive stance. Pick the width that matches how much flare you want to cover, and the set arrives pre-cut for all four corners. If you are running larger tires or aftermarket flares, measure the flat surface area first so the coverage lands where you expect it.

Matte Finish That Reads as Paint, Not Sticker

The matte black surface is the whole point here. It has no shine, so it blends with textured plastic and flat paint instead of sitting on top of them like a glossy label. Light scatters evenly across the surface, which helps hide minor scuffs from brush, dirt, and car washes. The low-sheen look also pairs well with blackout badges, dark wheels, and bed rack hardware. If you ever want a different character, the same cut is available in gloss, clear, and static cling finishes from our shop.

Install with Soap, Water, and a Squeegee

Application is a wet-install process, which gives you room to slide each piece into position before it grabs. Clean the flares with isopropyl alcohol, mist the surface with slip solution, place the decal, and squeegee the liquid out from the center. The vinyl conforms to the flare's curves with a little heat from a hair dryer on cooler days. Full sets typically go on in a couple of hours with basic tools. When it is time to remove or replace a piece, warm it and peel; the shop prints each set to order, so you can reorder a single corner later if one takes a hit on the trail.

What you get

• Cut to fit Jeep Gladiator JT fender flare surfaces
• Matte black finish blends with textured plastic
• Sold as a full set covering all four flares
• Width options from 12 to 48 inches
• Wet-install application with slip solution and squeegee
• Printed on cast vinyl that conforms to flare contours
• Removable with heat when you want to change the look

Specifications

Frequently asked questions

Will these fit my Jeep Gladiator JT?

Yes, the set is cut for the fender flares of the Gladiator JT platform. Not affiliated with or endorsed by the manufacturer. If you have swapped to aftermarket flares, measure your flat flare surface and compare it to the width option before ordering.

How do I pick the right width?

Narrower widths cover the flare edge for a subtle blackout, while wider options extend toward the body line. Measure the flat area of your flare you want covered and choose the closest option within the 12 to 48 inch range.

Can I take them off later?

Yes. Warm the decal with a hair dryer or heat gun on low and peel slowly. Any residue can be cleaned with isopropyl alcohol, leaving the factory flare underneath as it was.