Jeep Gladiator Rocker Panel Stripe Decals | LEO Sticker

Description

Matte and gloss rocker panel stripe decals sized and cut for Jeep Gladiator doors and lower body panels. A simple way to add contrast along the rocker area without paint or permanent changes.

Rocker Panel Stripes Made for the Gladiator

These stripe decals are shaped to follow the lower body line of the Jeep Gladiator, covering the rocker panel area between the wheels. Each set is cut as a pair, one for each side of the truck, so the layout matches from driver to passenger side. The stripes give the lower panels a two-tone look that stands out against the body color, and they do the job of protecting the visual area that takes the most road grime and stone chips. Because they are vinyl decals rather than paint, you can change the look or remove it later without body shop work. Not affiliated with or endorsed by the manufacturer.

Choose Your Width and Finish

Every set is available in widths from 12 to 48 inches, so you can decide how much of the rocker area you want to cover. A narrower stripe sits close to the sill line for a subtle accent, while wider options reach higher up the door and quarter panel for a bolder contrast panel. Finish choices include matte for a low-sheen, flat look, gloss for a painted-on shine, clear for a barely-there protective layer, and static cling for a temporary hold that peels off clean. Pick the combination that matches how you use your truck, from daily driver to trail rig.

How They Install on the Rocker Panels

Installation is a wet or dry application with transfer tape, and the process is the same as most vinyl decals. Start by cleaning the rocker area with isopropyl alcohol and letting it dry fully. Peel the backing, position the stripe along the panel line, and squeegee from the center outward to push out air and moisture. The vinyl conforms to the gentle curves of the rocker area, and edges can be tucked with a little heat from a hair dryer on cool days. Full instructions ship with every set, and a second set of hands makes alignment easier on the longer widths.

Pairing With Other Jeep Gladiator Decals

Rocker stripes work well on their own, but they also layer into a larger graphics plan. Many buyers combine them with hood stripes, door decals, or tailgate lettering from our Jeep Gladiator decals collection to build a coordinated theme across the truck. Keeping the same finish across pieces gives the setup a consistent look, while mixing matte stripes with a gloss hood stripe creates deliberate contrast. If you trail the truck often, the rocker set is a practical first piece since that zone sees the most contact from dirt, sand, and kicked-up gravel.

What you get

• Sold as a matched pair, one stripe per side
• Width options from 12 to 48 inches
• Cut to follow the Gladiator rocker panel line
• Available in matte, gloss, clear, and static cling finishes
• Printed on cast or calendered vinyl with application tape included
• Removable without paint or body work
• Installation guide included with every set

Specifications

Frequently asked questions

Do these fit a Jeep Gladiator with aftermarket fender flares?

The stripes are cut for the factory rocker panel line. Aftermarket flares may cover part of the stripe edge, so measure your visible rocker area and choose a width that stays clear of the flare. Not affiliated with or endorsed by the manufacturer.

Can I take them off later?

Yes. Peel the vinyl up from an edge, working slowly. Warming the decal with a hair dryer helps release the adhesive. Any remaining adhesive can be cleaned off with isopropyl alcohol. Static cling versions simply peel off with no residue.

Which width should I pick?

It depends on the look you want. Narrower widths near 12 inches sit low along the sill for a subtle accent, while wider options up to 48 inches cover more of the door and quarter panel. Measure your rocker area first to confirm the coverage you want.