By vehicle
By style
By position
Guides
Marine & water
Powersports
Storefront & office
Labels & packaging
Bulk & wholesale
Send your own artwork
Upload your logo or sketch on any product page: we cut it in the width you choose.
Shop
Kids & anime
Sports & fan
Custom stickers
Start here
Your design, our vinyl
Send a sketch or logo, optional upload box sits under the size selector on every product.
Finishes we print
Sizes we cut
12"18"24"36"48"
A bald eagle talon and American flag vinyl decal set for cars, trucks and trailers. Printed on cast vinyl with a choice of matte, gloss, clear or static cling finish.
JPG, PNG, WEBP or PDF, up to 20 MB. Leave this empty to order the design shown above.
This decal pairs the grip of bald eagle talons with a flowing American flag design, made for truckers, veterans and anyone who wants their pride visible from three lanes over. Each set is printed on cast vinyl and cut to a clean contour so the artwork sits flat against paint, glass or toolboxes. You choose the finish that fits your rig: matte for a low-profile look that hides glare, gloss for maximum pop, clear for a layered window application, or static cling if you want to remove and reposition it later. Sizes run from 12 inches up to 48 inches wide, so the same design works on a sedan rear window, a pickup tailgate or the side of a sleeper cab.
Pick the width that matches where you plan to apply it. The 12-inch and 18-inch sizes suit car windows, mirrors and cooler lids. The 24-inch and 30-inch options fill a pickup tailgate or the lower door panel of a work truck. The 36-inch and 48-inch widths are made for semi trailers, flatbeds and box trucks, where the talon detail really gets room to stretch. Because every set is cut to order, the proportions of the eagle and flag stay consistent across the size range rather than stretching or distorting. Measure your application area before ordering, and remember to account for door handles, hinges and body lines so the design lands where you want it.
Application is a straightforward wet-or-dry process with transfer tape, and every set ships with illustrated instructions so you are not guessing at the first attempt. Clean the surface with isopropyl alcohol and let it dry completely. Peel the backing, position the decal, and squeegee from the center outward to push out air and moisture. On larger sizes, a helper holding one edge makes alignment much easier. The vinyl conforms to gentle curves like tailgates and fuel doors, though we recommend avoiding deep body creases. Static cling versions press onto smooth glass with no adhesive at all and peel away clean, which makes them a good choice for leased vehicles or seasonal displays.
We print and cut every decal in-house at our US shop, which means quality control happens on our floor, not overseas. Inks are laid down in fade-resistant layers so the reds and blues of the flag hold their depth under sun and highway grime. Cast vinyl is thin and flexible compared to calendered options, so edges resist lifting on curved panels. Whether this decal rides on a daily commuter, a farm truck or a cross-country rig, it is printed to look sharp up close and at 70 miles per hour. Add it to a toolbox, trailer door or rear window and let the flag do the talking.
Applied to factory paint in good condition, the vinyl removes without damaging the finish. Warm the decal gently with a hair dryer and peel slowly at a low angle, then clean off any adhesive residue with isopropyl alcohol.
Most full-size tailgates fit a 24-inch or 30-inch decal comfortably. Measure the flat area between the tailgate edges first, and avoid overlapping badge or handle recesses so the contour-cut edges lay flat.
Yes. Choose the static cling finish, which uses no adhesive and peels off glass cleanly. Note that static cling works best on smooth glass rather than textured painted panels.
12", 18", 24", 36", 48"
There are no reviews yet.
You must be logged in to post a review.
Your shopping cart is empty
Notifications
