By vehicle
By style
By position
Guides
Marine & water
Powersports
Storefront & office
Labels & packaging
Bulk & wholesale
Send your own artwork
Upload your logo or sketch on any product page: we cut it in the width you choose.
Shop
Kids & anime
Sports & fan
Custom stickers
Start here
Your design, our vinyl
Send a sketch or logo, optional upload box sits under the size selector on every product.
Finishes we print
Sizes we cut
12"18"24"36"48"
A matte, gloss, or clear American flag stripe decal kit designed to dress up the hood of your Jeep Wrangler. Cut-to-order cast vinyl in a range of widths so you can size the stripes to your build.
JPG, PNG, WEBP or PDF, up to 20 MB. Leave this empty to order the design shown above.
This hood decal kit lays out the stars and stripes in a set of individual stripe pieces you position yourself, so the flag flows across the hood of your Jeep Wrangler with a clean, custom look. Each stripe is cut from cast vinyl that conforms to the gentle curves and body lines of the hood without lifting at the edges. Because the stripes are separate pieces, you can run the full flag across the hood, split it between panels, or trim the ends for a shorter accent. Choose a width from 12 to 48 inches to match how bold you want the statement to be, from a subtle corner accent to a full-width flag treatment.
Every kit is printed on your choice of finish. Matte gives the flag a flat, low-sheen military-inspired look that reads well against flat or low-gloss paint. Gloss adds depth and shine that stands out against duller paint. Clear vinyl lets the flag sit over your paint color so the hood shows through the design for a layered, ghosted effect. All three finishes use the same cast vinyl base, so the stripes hold their shape around hood contours. If you run topless in summer or through winter road grime, the vinyl surface wipes clean with mild soap and water the same way your paint does.
The kit is sold as a complete set with width options from 12 inches up to 48 inches. A 12-inch set works as a small accent near the hood edge or on a hood reinforcement panel. Mid-range sizes in the 24 to 36 inch band cover a good portion of the hood on most Wrangler generations. The 48-inch set spans nearly the full hood width for a dramatic flag layout. Measure the flat area of your hood between the fender lines before ordering, and pick a width that leaves a little breathing room at the edges. Wider sets can be trimmed during installation if you want a tighter fit.
Application is a dry or wet install with a squeegee and masking tape. Lay out the stripes first with tape hinges to confirm spacing, then peel and press each stripe down working from the center outward to push out air. Cast vinyl is forgiving during placement, so you can lift and reposition a stripe if it lands crooked. Park in the shade and work when the hood surface is clean, dry, and not hot to the touch. After install, avoid pressure washing directly at the stripe edges for the first day or two. For ongoing care, hand wash with mild soap and skip harsh solvents or abrasive pads over the graphics.
The kit is cut for the Jeep Wrangler hood and sold in widths from 12 to 48 inches. Measure the flat area of your hood between the fender lines and choose the width that fits. Stripes can be trimmed during installation for a tighter fit. Not affiliated with or endorsed by the manufacturer.
Matte gives a flat, subdued military-inspired look. Gloss adds shine and contrast. Clear vinyl lets your paint color show through the flag design for a ghosted effect. All three use the same cast vinyl, so the choice is purely about the look you want.
Yes. Warm the vinyl with a hair dryer or heat gun on a low setting and peel it away slowly at a shallow angle. Any leftover adhesive can be cleaned off with a mild adhesive remover. Avoid pulling cold vinyl in freezing weather, as it can tear instead of peeling cleanly.
12", 18", 24", 36", 48"
Your shopping cart is empty
Notifications
