4x4 Canadian Flag Decal Set of 2 | Offroad Truck Stickers

Description

A set of two 4x4 Canadian flag vinyl decals made for trucks, Jeeps, SUVs and trailers. Choose from 12 to 48 inch widths to fit your rig.

Canadian Pride for Your 4x4 Build

If your rig spends its weekends on rocky trails, muddy forest roads or long highway stretches north of the border, this 4x4 Canadian flag decal set lets you wear that pride right on the bodywork. Each order includes two matching decals, so you can run one on each side of your truck bed, one on the tailgate and one on the hood, or keep the second as a spare for a future build. The classic 4x4 badge sits inside the maple leaf flag design, a look that reads clearly from a distance and pairs well with lift kits, roof racks and trail armor. It is a simple way to mark your truck as a wheeler without adding clutter.

Cut Vinyl Built for Trail Dust and Highway Rain

These decals are printed and cut on cast vinyl, a thin, conformable material that follows the gentle curves of fenders, doors and tailgates. Choose the finish that suits your build: matte for a low-key, painted-on look that softens glare in photos, gloss for a clean shine that matches factory paint, or clear for a subtle layout where the flag appears to float on the surface. The inks are printed directly onto the vinyl, and applied correctly the decals hold up to regular washing and everyday driving. Because there is no background film in the cut style, the design sits flush against paint rather than trapped under a printed rectangle.

Pick Your Size from 12 to 48 Inches

Every rig is different, so this set comes in a range of widths from 12 inches up to 48 inches. A 12 to 18 inch pair works well on side mirrors, rear windows or toolboxes. Mid sizes around 24 to 30 inches suit tailgates, camper shells and off-road SUV hoods. The larger 36 and 48 inch options are made for full-size truck beds, trailers and the sides of overland builds where you want the flag readable from a distance. Measure the flat area you plan to apply before ordering, and leave a little margin around the edges so the decal does not cross body lines or trim pieces that could cause lifting over time.

Applying Your 4x4 Decals

Application takes a few minutes with basic tools: a squeegee or credit card, some masking tape to position the decal, and a clean surface free of wax and dust. Start by wiping the area with isopropyl alcohol and letting it dry fully. Tape the decal in place, check the alignment from a few steps back, then peel the backing and smooth it down from the center outward. Work air bubbles toward the edges rather than pressing them flat. On cold days, warm the surface slightly so the vinyl conforms. Wait a day or two before pressure washing near the decal so the adhesive fully bonds to the paint or glass.

What you get

• Set of 2 matching 4x4 Canadian flag decals
• Available in 12, 18, 24, 30, 36 and 48 inch widths
• Cast vinyl with matte, gloss or clear finish options
• Die-cut design with no background film for a painted-on look
• Suitable for truck beds, tailgates, hoods, windows and trailers
• Weather-resistant inks intended for outdoor use
• Made to order in the USA

Specifications

Frequently asked questions

Do I get two decals or one?

Each order includes two identical decals so you can place them on both sides of your vehicle, or save the second for another rig.

Will these decals damage my paint when removed?

When applied to factory paint in good condition and warmed gently with a hair dryer during removal, the vinyl should lift without leaving residue. Any leftover adhesive can be cleaned with isopropyl alcohol.

What size should I choose for a truck tailgate?

Most full-size tailgates fit a 24 to 30 inch width comfortably. Measure the flat area between the handle and the tailgate edges before ordering to confirm the best fit.