By vehicle
By style
By position
Guides
Marine & water
Powersports
Storefront & office
Labels & packaging
Bulk & wholesale
Send your own artwork
Upload your logo or sketch on any product page: we cut it in the width you choose.
Shop
Kids & anime
Sports & fan
Custom stickers
Start here
Your design, our vinyl
Send a sketch or logo, optional upload box sits under the size selector on every product.
Finishes we print
Sizes we cut
12"18"24"36"48"
A ripped-flag vinyl decal kit that adds a bold patriotic accent to pickups, semis and trailers. Sold as a matched set in widths from 12 to 48 inches.
JPG, PNG, WEBP or PDF, up to 20 MB. Leave this empty to order the design shown above.
This decal kit recreates the look of a flag tearing across your vehicle, with layered red, white and blue panels printed on cast vinyl and precision-cut for a clean, ragged edge. The set is designed so the tear lines flow naturally over tailgates, sleeper doors or trailer panels, and each piece is cut in proportion so you can run the same design on a compact pickup or a full-size semi. Choose a width from 12 to 48 inches and the kit scales with it. It is a straightforward way to add an american flag decal look to a working truck without paint, wraps or permanent modification, and it installs with basic tools in a single afternoon.
The tear design is split into two halves: one side carries the stars and stripes, the other carries the torn-away edge and trailing strips. When you place the halves with a gap between them, the paint or body color shows through and reads as the rip itself. That gap is up to you, so the effect can look subtle on a daily driver or dramatic across a semi sleeper. Because the design is cut rather than printed as one solid rectangle, there are no background edges to hide, and the decal sits flush against the panel. We include placement guides so both halves line up level from side to side.
Every kit is printed on cast vinyl, which conforms to gentle curves, panel seams and rivet lines without lifting at the edges. You can order the kit in a matte finish for a low-profile, weathered look that reads well against flat paint, or a gloss finish for colors that pop in direct sun. Static cling and clear options are also available if you want a temporary display or a layered look over existing graphics. Cast vinyl holds its cut edges cleanly over time and resists the flexing and vibration that working trucks see every mile, from gravel roads to highway runs.
Start with a clean, dry, wax-free surface; a quick wipe with isopropyl alcohol removes the residue that causes lifting. Warm the decal slightly with a heat gun or hair dryer so it relaxes into curves, then apply from the center outward with a squeegee to push out air. The cast vinyl stretches a little around rivets and body lines, so take your time on those areas rather than forcing the material. Keep the vehicle dry for the first day so the adhesive sets fully. If you ever want to remove the kit, warm it again and peel slowly, then clean off any adhesive residue with alcohol.
Measure the flat area where you plan to place the decal, including the space you want between the two halves. A 12-18 inch width works well on tailgates and compact cabs, while 36-48 inch widths suit full-size pickups and semi sleepers. Order a width that leaves at least an inch of clearance at body lines and trim.
Yes. Cast vinyl is designed to conform, and with gentle heat and firm squeegee pressure it wraps around rivets and shallow corrugations. Deeply textured or heavily rusted surfaces should be repaired or avoided, since the vinyl needs a smooth surface to bond.
Warm the decal with a heat gun or hair dryer and peel it back slowly at a low angle. Original, well-adhered paint is typically unaffected. Freshly painted or repainted surfaces should cure fully before applying any decal.
12", 18", 24", 36", 48"
There are no reviews yet.
You must be logged in to post a review.
Your shopping cart is empty
Notifications
