By vehicle
By style
By position
Guides
Marine & water
Powersports
Storefront & office
Labels & packaging
Bulk & wholesale
Send your own artwork
Upload your logo or sketch on any product page: we cut it in the width you choose.
Shop
Kids & anime
Sports & fan
Custom stickers
Start here
Your design, our vinyl
Send a sketch or logo, optional upload box sits under the size selector on every product.
Finishes we print
Sizes we cut
12"18"24"36"48"
A ripped or torn American flag decal set printed on cast vinyl, made for truck owners who want a bold patriotic look on doors, tailgates or toolboxes. Available in widths from 12 to 48 inches, sold as a matching pair.
JPG, PNG, WEBP or PDF, up to 20 MB. Leave this empty to order the design shown above.
This ripper tear design gives your truck the look of the flag tearing through the surface underneath it, with frayed edges that read clearly from a distance. Each order includes two mirrored decals so both sides of your cab, bed or toolbox can carry the same graphic. The set works well on pickup doors, tailgates, semi-trailer panels, coolers and garage doors. Choose a width between 12 and 48 inches at checkout; the height scales with the width so the flag keeps its proportions. If you have been searching for an american flag decal that stands out from standard rectangle flags, this torn-edge style adds motion and depth without any custom artwork required.
Every pair is printed in-house on cast vinyl with your choice of four finishes. Matte cuts glare and blends into flat paint, which suits work trucks and darker colors. Gloss adds shine that pops against matte or faded paint. Static cling uses no adhesive, so it peels off clean when the season ends or you swap designs. Clear finish keeps the focus on the printed flag itself with a nearly invisible border. All four finishes apply the same way: peel, position and squeegee down. Pick the finish that matches how long you plan to run the graphic and how much sun your truck sits in. If you change vehicles often, static cling is the easiest to move.
Measure the flat area where you plan to place each decal before ordering, and compare that measurement to the width options. A 12 inch pair suits toolboxes, windows and smaller panels. Mid sizes in the 18 to 24 inch range fit most pickup door faces. The 30 to 36 inch widths fill a tailgate or a semi door nicely. The largest 48 inch option covers full trailer panels or long bed sides. Leave about an inch of clearance around the graphic so the frayed edges do not wrap over body lines or trim. Because the pair is mirrored, one decal faces left and one faces right, so confirm which side gets which before you peel the backing.
Apply to a clean, dry surface when the temperature is mild and the truck is out of direct sun. Wash the area, remove wax with rubbing alcohol and let it dry fully. Peel the backing, tack the decal at one edge and squeegee from the center outward to push air out. The cast vinyl conforms to gentle curves and body lines. After application, wait a day before washing the truck, and avoid pressure washers aimed directly at the edges. Hand washing with mild soap keeps the frayed edges lying flat. If you chose static cling, the same placement steps apply, and you can reposition it during installation until it sits straight.
You receive a set of two mirrored decals, so you can dress both sides of your truck or place one on the tailgate and one on a door.
Measure the flat surface where the decal will go and pick the closest width that fits with about an inch of clearance. Heights scale with the width to keep the flag proportional.
Yes. Warm the decal with a hair dryer and peel it off slowly. Static cling removes without heat or residue. Removal results can vary with surface condition and how long the decal has been applied.
12", 18", 24", 36", 48"
There are no reviews yet.
You must be logged in to post a review.
Your shopping cart is empty
Notifications
