Tribal Spike Vinyl Decal Set for Cars & Trucks

Description

A set of tribal spike decals cut from cast vinyl, made for drivers who want an aggressive flame-and-spike look on their car or truck. Available in widths from 12 to 48 inches with a matte, gloss, or clear finish.

Tribal Decals Built for Cars and Trucks

This tribal spike decal set brings a sharp, pointed graphic treatment to doors, fenders, tailgates, and hoods. Each spike is cut individually from cast vinyl so the design follows body lines instead of fighting them, and the set arrives ready to place with transfer tape holding the layout together. Whether you drive a lowered street car or a lifted work truck, the spike pattern reads clearly from a distance and holds its edges up close. Choose a width between 12 and 48 inches to match the panel you are working with, from a subtle accent near the mirror to a full side graphic. The look is bold without being busy, which is exactly what most buyers want from a tribal set.

Choose Your Width and Finish

Every order is cut to the width you select at checkout, so measure your panel before ordering and pick the size that fits with room to spare. Smaller widths work well on cowl panels, mirror caps, and above the wheel arches, while the larger sizes fill doors and bed sides on full-size trucks. Finish is your call: matte for a low-key, painted-on look; gloss for a graphic that pops against flat paint; or clear for a subtle tone-on-tone effect on darker vehicles. All three finishes use the same cast vinyl, so the choice is purely visual. If you are layering the spikes with other graphics, matte tends to sit back while gloss steps forward, which helps you control depth in the overall layout.

How to Apply Your Spike Set

Application works best on a clean, dry panel above about 60 degrees Fahrenheit, out of direct sun. Wash the area, remove any wax or residue with isopropyl alcohol, and let the surface dry fully. Position the decal with small strips of tape as a hinge, peel the backing, and squeegee from the center outward to push air toward the edges. The transfer tape lifts off while the vinyl stays put. Two people make the wider sizes easier to handle, especially past 36 inches. Take your time aligning the first spike, since the rest of the set follows that lead. Full step-by-step instructions ship with every order, and a felt-edge squeegee makes the job smoother if you have one.

Care and Removal

Once applied, the decals can be washed with normal car soap and a soft mitt or cloth. Skip high-pressure spray wands aimed directly at the edges, and avoid scraping ice or heavy brush car washes over the graphics, since both can lift a corner over time. If you want to remove the set later, warm the vinyl with a hair dryer or heat gun on a low setting and peel slowly at a shallow angle; any remaining adhesive generally comes off with an adhesive remover and a microfiber towel. Because the vinyl is cut thin and flexible, it conforms to curves and panel seams without the heavy buildup you get with thicker graphic films, which also makes removal more forgiving on factory paint.

What you get

• Set of tribal spike decals cut from cast vinyl
• Available in 12", 18", 24", 36", and 48" widths
• Choice of matte, gloss, or clear finish
• Ships pre-masked with transfer tape for aligned placement
• Individual spike cuts let the design follow body lines
• Suitable for doors, fenders, hoods, tailgates, and bed sides
• Printed and cut in the USA

Specifications

Frequently asked questions

Do I get one decal or a pair?

This listing is for one set. If you want matching graphics on both sides of your vehicle, order two sets so you can mirror the placement yourself during installation.

Which width should I choose for a full-size truck door?

Most full-size truck doors work well with the 24" or 36" width, depending on how much of the panel you want to cover. Measure the flat area of the door first and choose a width that leaves margin on all sides.

Will these damage my paint when removed?

When warmed and peeled slowly, the vinyl typically releases without pulling paint. Original factory paint in good condition handles removal best; we cannot make guarantees about repainted or repaired panels.