Gloss Racing Stripes Kit - Toyota Decals 4-18 Inch

Description

A gloss vinyl racing stripes kit for car owners who want a clean motorsport look without a wrap visit. Cut from Cast Vinyl in your choice of 4, 8, 12 or 18 inch stripe widths.

Why Drivers Choose These Toyota Racing Stripes

Racing stripes are one of the simplest ways to change the personality of a car, truck or SUV, and this kit makes the upgrade approachable for everyday drivers. Each set is cut from gloss Cast Vinyl that lays down with a smooth, paint-like shine, so the stripes read as part of the vehicle rather than a stuck-on afterthought. You pick the stripe width that fits your build, from a slim 4 inch accent to a bold 18 inch center stripe, and apply the kit at home with basic tools. There is no printing, no cutting on your end, and no need to remove the stripes for car washes or daily driving. It is a weekend project with a motorsport payoff.

Matte, Gloss, Clear and Cling: Choosing the Right Look

This listing is for the gloss finish, which gives the stripes a wet-look shine that pairs well with clean or freshly waxed paint. If you prefer something quieter, the same kit is available in a matte finish that reads flat and understated, a clear option for a subtle tone-on-tone effect, and a static cling version for drivers who want a temporary look they can reposition or remove in seconds. Gloss is the most popular pick for classic racing applications because it catches light along the hood and roofline the way painted stripes would. All four finishes use the same cut pattern, so you can switch looks later without changing the layout.

How to Apply Your Stripe Kit in an Afternoon

Start by washing the vehicle thoroughly and letting the surface dry completely, then work in a shaded area out of direct sunlight so the vinyl stays easy to handle. Lay each stripe section out on the hood or roof first to confirm alignment, using the center seam or body lines as your guide. Peel the backing, tack one edge down, and squeegee outward from the center to push air out as you go. The Cast Vinyl conforms to gentle curves and body lines when warmed slightly with a hair dryer. Take your time on the first stripe, since it sets the alignment for the rest. Most drivers finish a full kit in a single afternoon.

Sizing Guide: 4, 8, 12 or 18 Inch Stripes

The kit comes in four stripe widths so you can match the look to your vehicle and your taste. The 4 inch width works well on smaller cars, hoods with tight panel gaps, and drivers who want a subtle twin-stripe accent. The 8 inch option is the classic dual-stripe proportion that most people picture when they think of racing stripes. The 12 inch width suits trucks, SUVs and larger hoods where slimmer stripes can get lost. The 18 inch single-stripe layout makes a bold statement on wide hoods and long rooflines. If you are between two sizes, measure the flat area between your body lines before ordering to see which width fits without wrapping over edges.

What you get

• Gloss Cast Vinyl with a smooth, paint-like shine
• Available in 4, 8, 12 or 18 inch stripe widths
• Pre-cut kit, no trimming or printing required
• Conforms to gentle curves and body lines when warmed
• Applied with a squeegee using dry or wet method
• Also available in matte, clear and static cling finishes
• Cut and shipped by our US-based

Specifications

Frequently asked questions

Will these stripes damage my paint?

When applied to factory paint in good condition and removed warm with care, the vinyl is designed to come off cleanly. We do not recommend applying over fresh or uncured paint, and you should test in a small area if your paint has been repaired.

Can I take my car through a car wash?

Wait at least a few days after application before washing so the vinyl fully bonds. After that, touchless washes are the gentlest option, and brush washes should be avoided since brushes can lift edges over time.

What if I make a mistake during application?

Work slowly and use the wet application method with soapy water if you are new to vinyl, which lets you slide the stripe into position before squeegeeing it down. Small air bubbles can be pushed out or popped with a pin.

Is this an official brand product?

Not affiliated with or endorsed by the manufacturer. It is an independent aftermarket Vinyl Decal.