By vehicle
By style
By position
Guides
Marine & water
Powersports
Storefront & office
Labels & packaging
Bulk & wholesale
Send your own artwork
Upload your logo or sketch on any product page: we cut it in the width you choose.
Shop
Kids & anime
Sports & fan
Custom stickers
Start here
Your design, our vinyl
Send a sketch or logo, optional upload box sits under the size selector on every product.
Finishes we print
Sizes we cut
12"18"24"36"48"
A single matte black racing stripe decal cut from Cast Vinyl, sized at 18 inches for car owners who want a clean, low-shine stripe look. Part of our Camaro racing stripes collection.
JPG, PNG, WEBP or PDF, up to 20 MB. Leave this empty to order the design shown above.
This listing is for a single decal measuring 18 inches, pre-cut from matte Cast Vinyl with application tape already in place. The matte finish absorbs light instead of reflecting it, so the stripe reads as a painted-on accent rather than a sticker. It works well on hoods, trunks, roof panels, or side body lines where a gloss stripe would fight the factory paint. The 18 inch length suits mid-size panels and gives you room to trim the ends for a custom fit. If you are building a full Camaro racing stripes layout, this single decal lets you place each stripe exactly where you want it without wrestling a long, unwieldy strip of vinyl.
Matte and flat paint jobs have become popular on muscle cars, and a gloss stripe on top of that finish stands out for the wrong reasons. This decal was cut for owners who want the stripe to disappear into the surface. The matte surface texture is uniform across the entire decal, with no shine line where the vinyl meets paint. It also pairs cleanly with gloss clearcoat if you prefer a subtle contrast instead of a full match. Because it is a single decal rather than a printed Graphic, there is no background film, no clear border, and no ink layer, just solid colored vinyl wherever the stripe runs.
Start with a clean, dry surface and a temperature between roughly 60 and 80 degrees Fahrenheit. Position the decal with the application tape facing out, using small strips of tape as hinges to hold alignment. Peel the backing away, then squeegee from the center outward to press the vinyl down and push air toward the edges. Work slowly over body curves, letting the vinyl stretch and conform rather than forcing it flat. Once the decal is fully adhered, pull the application tape back over itself at a low angle. Wait about a day before washing the car so the adhesive sets. Any trapped air can be punctured with a pin and smoothed flat.
Not every panel needs an 18 inch stripe. This same matte decal is offered in 4, 8, and 12 inch sizes so you can mix lengths across a build, shorter pieces for fenders and mirrors, longer ones for hoods and quarter panels. Buying individual decals instead of a fixed kit means you only pay for the stripes you actually use. All sizes are cut from the same matte Cast Vinyl with the same adhesive, so the finish stays consistent when you combine them. Choose your size at checkout, and if you are planning a multi-stripe layout, measure each panel first and order the length that fits with a little room to trim.
This listing is for a single decal. If you want a twin-stripe layout, order two and space them to your preference. Ordering singles gives you control over the gap width between stripes.
Matte vinyl sits close to most flat and matte paint finishes, though exact texture matches vary by paint. Many owners pair it with gloss paint for a subtle contrast instead.
Yes. Trim the ends with a sharp blade after positioning, or cut the decal before application. The 18 inch length includes a little extra material for a custom fit.
Not affiliated with or endorsed by the manufacturer. It is an independent aftermarket Vinyl Decal.
4 inch, 8 inch, 12 inch, 18 inch
Your shopping cart is empty
Notifications
