By vehicle
By style
By position
Guides
Marine & water
Powersports
Storefront & office
Labels & packaging
Bulk & wholesale
Send your own artwork
Upload your logo or sketch on any product page: we cut it in the width you choose.
Shop
Kids & anime
Sports & fan
Custom stickers
Start here
Your design, our vinyl
Send a sketch or logo, optional upload box sits under the size selector on every product.
Finishes we print
Sizes we cut
12"18"24"36"48"
A static cling rear window Graphic for truck and SUV owners who want a bold look without adhesive. Pairs well with any Ford Bronco decal kit and applies in minutes.
JPG, PNG, WEBP or PDF, up to 20 MB. Leave this empty to order the design shown above.
If you are building out a Ford Bronco decal kit and want the rear glass covered too, static cling is the easiest way to do it. There is no adhesive, so nothing bonds permanently to the window. You position the Graphic, smooth it out, and it holds through normal driving. When you want a change, you peel it off and the glass is clean underneath. That makes it a good option for leased vehicles, daily drivers, or anyone who likes to rotate their look seasonally. It also means no scraping, no solvent, and no sticky residue left behind after removal, which is the main complaint people have with adhesive-backed window decals.
Application works best on a clean, dry window, so wash the glass and let it fully dry before you start. Lightly mist the glass with water mixed with a drop of dish soap, then lay the Graphic in place. The water lets you slide it around until the position is right. Use a squeegee or a soft card to push water and air out from the center toward the edges, then blot the edges with a paper towel. On a rear window with a defroster, work gently and avoid pressing the Graphic over defroster lines until it has set. Static cling material is forgiving, so if you get it crooked the first time, you can lift and reset it without damaging the print.
This Graphic is offered in decal sizes of 4, 8, 12, or 18 inches, so you can match it to the window you are covering. The smaller sizes suit side glass, corner accents, or a subtle addition next to other decals, while the larger sizes work better on rear windows where you want the design to fill the space. Measure your glass before ordering and remember that the listed size refers to the longest dimension of the decal. If you are layering this with other pieces from your kit, leaving a little breathing room around the Graphic usually looks cleaner than packing everything edge to edge.
To keep the Graphic looking sharp, wash around it gently rather than blasting it with a pressure washer at close range. Automatic car washes with soft cloth are generally easier on static cling than brush-style washes. If you remove the Graphic and want to reuse it later, place it back on its original liner or between two clean sheets of plastic, and store it flat and out of direct heat. Avoid folding it, since creases can show once it is reapplied. With basic care, the print stays clean and the cling stays tacky enough to remount. For best results, reapply to a freshly cleaned window so dust does not get trapped between the film and the glass.
Yes, static cling holds to clean glass through normal driving conditions. Make sure the glass is free of dust and wax before applying, and squeegee out all water so the film makes full contact with the glass.
You can. Peel it off carefully, place it back on its liner or between clean plastic sheets, and store it flat. Reapply to a freshly cleaned window for the best cling.
No. Static cling uses no adhesive at all, so when you remove it the glass is clean underneath with nothing to scrape off.
Not affiliated with or endorsed by the manufacturer. It is an independent aftermarket Vinyl Decal.
4 inch, 8 inch, 12 inch, 18 inch
Your shopping cart is empty
Notifications
