Dart Boat Stripe Decals | Vinyl Boat Decals Set

Description

A set of dart-style stripe decals cut from marine-grade cast vinyl, made for boat owners who want a clean graphic accent on their hull. Available in widths from 12 to 48 inches.

Dart Stripe Decals for Your Boat Hull

The dart stripe is a classic hull graphic, with angled lines that taper toward the bow and give a small runabout or a full-size fishing boat a sharper profile. This decal set is cut to order from cast vinyl in your choice of width, from 12 inches up to 48 inches, so you can match the stripe to the length and style of your boat. Each set includes both port and starboard pieces, mirrored so the design lines up evenly on both sides of the hull. Whether you are dressing up a jon boat, a pontoon, or a center console, these boat decals are a straightforward way to add a custom look without a professional wrap.

Matte, Gloss, Clear and Static Cling Options

Every dart stripe set is printed in one of four finishes we run in-house. Matte gives a painted-on look that blends into a non-glossy hull. Gloss adds shine that stands out against a faded gelcoat. Clear vinyl carries the printed stripe on a transparent carrier, so only the stripe itself shows once installed. Static cling uses no adhesive at all, holding to smooth gelcoat or glass by suction alone, which makes it a good pick if you want to remove the stripes seasonally or test placement before committing. All four finishes are printed with inks rated for outdoor exposure on the water.

Applying Your Dart Boat Decals

Installation works best on a clean, dry hull above the waterline. Wash the area with soap and water, remove any wax with a prep solvent, and let the surface dry fully before peeling the backing. On cool mornings, warm the decal and the hull slightly so the vinyl conforms to any curve in the bow. Align the widest end near the stern and let the taper run forward, using masking tape to hold position before squeegeeing from the center outward. Static cling pieces simply press on and can be repositioned by peeling and reapplying. Full step-by-step instructions ship with every set.

Why Boat Owners Choose LEO Sticker

We print every dart stripe set to order at our US shop rather than pulling stock from a warehouse shelf, so each set is cut to the exact width you select. Our cast vinyl conforms to curved hull surfaces and resists the sun, spray, and rinse-down routine that comes with boat life. If you are unsure which width fits your boat, send us the straight-line length of the area you want to cover and we will help you pick a size before you order. We also keep our pricing well below what marine graphics shops charge for comparable stripe sets, with no minimum order.

What you get

• Set includes mirrored port and starboard dart stripe pieces
• Choose your width from 12 to 48 inches
• Printed on cast vinyl that conforms to curved hull surfaces
• Four finish options: matte, gloss, static cling, and clear
• Outdoor-rated inks built for sun and spray exposure
• Printed to order in our US shop
• Includes step-by-step application instructions

Specifications

Frequently asked questions

How do I pick the right stripe width for my boat?

Measure the straight-line distance along the hull where you want the stripe to sit, from stern toward the bow. Pick the width that fits within that space. If you are between sizes, send us your measurement and we will help you choose.

Will these decals hold up in the water?

The adhesive-backed sets use cast vinyl with outdoor-rated inks, intended for use above the waterline. Rinse with fresh water after saltwater outings, and avoid high-pressure washing directly against the stripe edges.

Can I remove the stripes later?

Yes. Warm the adhesive-backed vinyl with a hair dryer or heat gun on low and peel slowly. Static cling pieces peel off with no heat and no residue, and can be reused if kept clean.