By vehicle
By style
By position
Guides
Marine & water
Powersports
Storefront & office
Labels & packaging
Bulk & wholesale
Send your own artwork
Upload your logo or sketch on any product page: we cut it in the width you choose.
Shop
Kids & anime
Sports & fan
Custom stickers
Start here
Your design, our vinyl
Send a sketch or logo, optional upload box sits under the size selector on every product.
Finishes we print
Sizes we cut
12"18"24"36"48"
A set of four gloss Cast Vinyl decals cut for ATV body panels, fenders and storage boxes. Made for riders who want to personalize their quad without repainting anything.
JPG, PNG, WEBP or PDF, up to 20 MB. Leave this empty to order the design shown above.
This decal pack gives you four matching designs cut from gloss Cast Vinyl, sized to work on the flat and gently curved surfaces of an ATV. The gloss finish catches light the same way painted plastic does, so once applied, the decals read as part of the machine rather than an add-on. Each decal is die-cut with a paper backing and premasked transfer tape, so you position it once, squeegee it down, and peel the carrier away. Choose 4, 8, 12 or 18 inch sizes depending on whether you are dressing up a fender, a rack box or the main body panels. The pack ships as a matched set so the look stays consistent across all four placements.
Start with a clean surface. Wash the panel with dish soap and water, dry it fully, then wipe the exact application area with isopropyl alcohol to remove any wax or residue. Let the panel come to room temperature before you begin. Peel the paper backing, hold the decal by the premask tape, and line it up by eye or with low-tack masking tape as a hinge. Squeegee from the center outward to push air toward the edges, then slowly pull the transfer tape back on itself at a flat angle. For the larger 12 and 18 inch sizes, a second set of hands helps keep the decal from folding back onto itself mid-application.
Mud, dust and pressure washing are part of ATV life, and gloss vinyl holds up to routine washing when you treat it like paint. Rinse loose grit off before wiping so particles do not scratch the surface. When pressure washing, keep the nozzle at a distance and avoid aiming the spray directly at the decal edges, since a direct hit at close range can lift a corner over time. Skip solvent-based cleaners on the graphics. If you ride through brush, inspect the edges occasionally and press down any lifted spot with a soft cloth while the surface is warm. Applied to a clean panel, the decals stay put through normal trail use.
Every decal in this pack is cut to the same size, so pick the dimension that fits your intended placement. The 4 inch size suits small panels, forks and tool boxes. The 8 inch size is the most popular for fenders and side panels. The 12 inch size works on rear racks and larger body sections, and the 18 inch size is for riders who want a bold statement across a main panel. Measure the flat area you plan to cover before ordering, and remember that a decal needs a smooth, unwaxed surface to bond well. Textured or heavily contoured plastics may not accept large decals cleanly, so check your panels first.
They bond best to smooth, clean surfaces. Lightly textured plastic can work for smaller sizes, but heavily textured panels may not hold the decal edges cleanly. Test fit a small area before applying the full set.
Yes, with care. Keep the nozzle at a normal washing distance and avoid spraying directly into the decal edges at close range, which can lift a corner over time.
Yes. Each pack contains four decals cut to the size you select at checkout, either 4, 8, 12 or 18 inches, so the set looks consistent across your machine.
Not affiliated with or endorsed by the manufacturer. It is an independent aftermarket Vinyl Decal.
4 inch, 8 inch, 12 inch, 18 inch
Your shopping cart is empty
Notifications
