By vehicle
By style
By position
Guides
Marine & water
Powersports
Storefront & office
Labels & packaging
Bulk & wholesale
Send your own artwork
Upload your logo or sketch on any product page: we cut it in the width you choose.
Shop
Kids & anime
Sports & fan
Custom stickers
Start here
Your design, our vinyl
Send a sketch or logo, optional upload box sits under the size selector on every product.
Finishes we print
Sizes we cut
12"18"24"36"48"
A dual racing stripe decal kit sized for car hoods, cut from cast vinyl in matte, gloss, clear or static cling finishes. For drivers who want classic stripe styling without paint.
JPG, PNG, WEBP or PDF, up to 20 MB. Leave this empty to order the design shown above.
Nothing says performance heritage like a pair of racing stripes running down the hood. This stripe kit brings that look to your daily driver with pre-cut vinyl panels sized to span the hood from cowl to front edge. Each set includes both left and right stripes, cut with matching tapers so the pair sits evenly on the panel. Choose a width from 12 to 48 inches to match the stance of your car, from a subtle twin accent to a bold muscle-car width. It is a straightforward way to change the character of your front end without committing to paint, and it can be removed cleanly when you are ready for a different look.
Every hood is different, so this kit is offered in a range of width options rather than one fixed size. Narrower sets suit smaller hoods and understated builds, while wider stripes make a stronger statement on full-size cars and trucks. Finish is where you can really dial in the style: gloss stripes read like painted striping, matte stripes give a modern low-sheen contrast against factory paint, clear finishes work over colored panels for a subtle tone-on-tone effect, and static cling offers a fully temporary option you can reposition or swap out. Measure the flat area of your hood before ordering so the pair fits within the panel without wrapping edges unless you want it to.
The stripes are cut from cast vinyl, a thin, conformable material that follows gentle hood curves without lifting at the edges. Applied to a clean, wax-free surface, the adhesive holds through car washes, rain, and sun exposure, while remaining removable with heat when you choose to take it off. The vinyl is printed and cut to shape in our shop, so each stripe arrives ready to position rather than trimmed by hand. Care is simple: wash as usual, avoid high-pressure sprayers pointed directly at stripe edges, and skip abrasive polishes over the decals. With basic care the stripes stay looking like part of the car, not an afterthought.
You do not need a shop to install this kit. The wet-application method works well for long stripes: spray the hood and the adhesive side with a slip solution, float the stripe into position, then squeegee the liquid out from the center outward. Because the vinyl can be shifted while wet, aligning the pair evenly is far easier than dry application. A felt-edge squeegee and a low-heat setting from a hair dryer help the material conform near hood contours. Most installs take an afternoon, and the kit ships with illustrated instructions. Take your time on alignment, since a level pair of stripes is what makes or breaks the look.
Measure the flat area of your hood between the outer contours, then compare it to the width options. A stripe set that sits fully on the flat panel is easiest to install; wider sets can wrap edges if you prefer that look.
Yes. Using the wet-application method, the stripes can be slid into position before the adhesive sets, which makes solo alignment much easier. A felt-edge squeegee and a helper for the final check are useful but not required.
On factory paint in good condition, the vinyl removes with gentle heat without leaving residue. We recommend warming the stripe and peeling it back slowly at a low angle rather than pulling straight up.
12", 18", 24", 36", 48"
Your shopping cart is empty
Notifications
