Spare Tire Cover Decals for Jeep Wrangler | LEO Sticker

Description

A vinyl spare tire graphic designed to dress up the rear wheel of your Jeep. Cut in a range of widths so you can match it to your tire cover or bare spare.

A Spare Tire Graphic Made for Jeep Owners

The back of a Jeep is the part everyone sees at the trailhead, the parking lot, and the car wash line. This spare tire decal gives that space some personality without permanent paint or powder coat. It is cut from cast vinyl with a pressure-sensitive adhesive, sized to sit on your spare tire cover or directly on the rubber, depending on how your rig is set up. Whether you run a soft top on the weekends or a full trail build year round, this is one of the simplest jeep decals to install and one of the first things people notice. Choose the width that matches your wheel, peel, and stick.

Sizing Your Decal to the Spare

Every Jeep setup is a little different, so this graphic is sold as a set with width options from 12 inches up to 48 inches. To pick the right size, measure across the face of your spare tire cover where you want the art to sit, and choose a width that leaves a margin on all sides. If you are applying to an uncovered spare, measure the flat tread face rather than the full tire diameter. A decal that is slightly smaller than the surface is easier to position and less likely to wrap over an edge. When in doubt, measure twice before ordering, since trimmed vinyl cannot be stretched to fit.

Matte, Gloss, Static Cling and Clear Options

You can order this tire graphic in the finish that suits your build. Matte blends in with textured tire covers and tonneau-style rear setups for a low-key look. Gloss adds depth and reads well against black rubber. Static cling uses no adhesive at all, so it holds by surface attraction and peels off clean when you want a change or need to pass an inspection. Clear vinyl lets the underlying surface show through the open areas of the design. All four finishes are printed in-house and cut to order, so your set ships as a matched group rather than pieced together from stock.

Application Tips and Everyday Care

Install on a clean, dry surface above about 60 degrees Fahrenheit if you can; warmer vinyl conforms better to slight curves. Wipe the tire cover or tread face with isopropyl alcohol and let it flash off completely. Peel the backing, align the top edge first, and smooth outward with a felt-edge squeegee or a soft cloth to push air toward the edges. Avoid high-pressure washers aimed directly at the edge of the graphic, and skip abrasive brushes at the car wash. For storage-season Jeeps, a coat of wax around, not on, the decal keeps the surrounding surface looking even. Fits Jeep Wrangler spare tires and covers. Not affiliated with or endorsed by the manufacturer.

What you get

• Sold as a set with width options from 12 to 48 inches
• Available in matte, gloss, static cling and clear vinyl
• Printed and contour-cut in-house to order
• Works on spare tire covers or directly on the tire tread face
• Pressure-sensitive cast vinyl with a peel-and-stick application
• Static cling option removes without adhesive residue
• Fits Jeep Wrangler spare tires and covers

Specifications

Frequently asked questions

How do I choose the right width for my spare tire?

Measure the flat face of your spare tire cover or the tread face of the bare tire, then pick a width slightly smaller than that measurement. Leaving a margin on all sides makes alignment easier and keeps the edges from wrapping over curves.

Will this decal stick to the rubber of an uncovered spare?

Yes. Clean the tread face with isopropyl alcohol and let it dry fully before applying. The static cling option is better if you want to remove or reposition the graphic often, since it uses no adhesive.

Can I remove the decal later?

Adhesive versions peel up when warmed gently with a hair dryer or heat gun on low. Any remaining adhesive can be cleaned with isopropyl alcohol. Static cling lifts off by hand with no residue.