Custom Color Block Tablet Back Skin Decal for Tech Devices

Description

A color block vinyl skin for the back of your tablet, cut to fit 12, 13, 15 and 17 inch devices. Made for anyone who wants a clean, layered look without adding bulk.

A Color Block Look for Your Tablet Back

This decal set brings a modern color block design to the back panel of your tablet. Each skin is printed on cast vinyl in your choice of matte, gloss or clear finish, with a layout of layered color panels you can customize to match your style. The thin material sits flush against the surface, so your tablet still slides into a sleeve or case the way it did before. It is a simple way to set your device apart from every other one on the desk, in the classroom or at the coffee shop, without committing to a case or a permanent change. Choose your size, pick your colors, and apply it in minutes.

Sized for 12, 13, 15 and 17 Inch Devices

The skin is offered in four device sizes: 12 inch, 13 inch, 15 inch and 17 inch. Measure the diagonal of your tablet screen before ordering so you can select the size that matches your device. The color block panels are arranged to cover the back surface with cut edges that follow a clean, geometric layout. Because the decal is trimmed to standard device dimensions rather than a one-size-fits-all sheet, the design lands where it should without excess material to fold or trim by hand. If you also decorate a laptop, this piece pairs well with other laptop stickers in the same finish.

Matte, Gloss, Static Cling or Clear Finish

Pick the finish that fits how you use your tablet. Matte cuts glare and hides fingerprints, which works well if you read or sketch for long stretches. Gloss gives the color panels a smooth, saturated look under indoor light. Static cling applies without adhesive and peels off clean whenever you want a change, a good option for shared or rented devices. Clear finish lets the original surface show through the open areas of the design. Every version is printed with inks designed for indoor use and applied dry or with light moisture depending on the style you choose.

How to Apply and Care for Your Skin

Start with a clean, dry back panel free of dust and oils. Peel the decal from its liner, align one edge, and smooth it across the surface with a soft card, working outward to push air toward the border. The vinyl conforms to flat areas and gentle curves without heat. For everyday care, wipe with a slightly damp microfiber cloth and avoid abrasive cleaners. When you are ready for a new design, warm the decal slightly with a hair dryer on low and peel it back slowly. Any leftover residue can be removed with mild soapy water and a soft cloth.

What you get

• Color block design printed on cast vinyl
• Available in matte, gloss, static cling and clear finishes
• Offered in 12, 13, 15 and 17 inch device sizes
• Custom color panel selection at checkout
• Thin profile keeps tablets sleeve and case friendly
• Peels away without leaving a sticky mess
• Printed in the USA

Specifications

Frequently asked questions

How do I pick the right size?

Measure the diagonal screen size of your tablet and choose the matching option: 12, 13, 15 or 17 inch. If your device falls between sizes, choose the smaller one so the edges sit within the back panel.

Will this work with a case?

The skin is thin enough for most sleeves and slim cases. Very tight-fitting hard cases may press against the edges, so test fit your case after applying if you plan to use one regularly.

Can I remove it later without damage?

Yes. Warm the decal gently with a hair dryer on low and peel it back slowly. Any residue can be cleaned with mild soapy water and a soft cloth.