By vehicle
By style
By position
Guides
Marine & water
Powersports
Storefront & office
Labels & packaging
Bulk & wholesale
Send your own artwork
Upload your logo or sketch on any product page: we cut it in the width you choose.
Shop
Kids & anime
Sports & fan
Custom stickers
Start here
Your design, our vinyl
Send a sketch or logo, optional upload box sits under the size selector on every product.
Finishes we print
Sizes we cut
12"18"24"36"48"
A pair of Cast Vinyl racing stripe decals designed to run along your hood, cut in your choice of 4, 8, 12 or 18 inch widths. Made to order in our US for drivers who want a motorsport look without paint.
JPG, PNG, WEBP or PDF, up to 20 MB. Leave this empty to order the design shown above.
These paired stripe decals bring a classic track-inspired accent to the front of your car, truck or crossover. Each order includes two matching stripes cut from Cast Vinyl, sized to your hood's proportions so you can set the gap between them exactly how you like it. The clean cut edges and even color laydown give the set a painted-on appearance once installed. Whether you drive a commuter sedan or a weekend project car, this is a simple way to change the character of the front end in an afternoon with nothing more than a squeegee and some patience.
Every set is offered in 4, 8, 12 or 18 inch stripe widths, so you can go subtle or bold depending on your build. Narrower pairs read as understated accents, while the wider cuts carry a stronger competition look. You also choose the finish: matte for a low-profile, flat look; gloss for a shine that reads like fresh paint; clear for an understated overlay; or static cling if you want a temporary option that peels off cleanly. Because each pair is cut after you order, the size you pick is the size that ships, with no trimming guesswork on your end.
Start with a clean, dry, wax-free hood and work in moderate temperatures out of direct sun. Position each stripe with masking tape as a hinge, peel a portion of the backing, and squeegee from the center outward to push air to the edges. Repeat down the length of the stripe, then remove the application tape at a low angle. The Cast Vinyl conforms to gentle hood curves and panel contours, and the air-release surface helps reduce bubbles during placement. Take your time aligning the two stripes as a pair before committing, since a symmetrical gap is what makes the finished look read as intentional rather than improvised.
Wash around the stripes by hand or with a gentle touch-free rinse, and avoid high-pressure sprays aimed directly at the edges. Avoid waxes and abrasives over the decal surface itself. When you are ready for a change, warm the vinyl gently with a hair dryer and peel it back slowly at a shallow angle; any remaining adhesive generally lifts with the film. If you want to refresh the look later, reorder the same width and finish, or try a different pairing from our racing stripe collection to restyle the hood again. Each set is packed with instructions and ships flat to protect the cut edges.
Measure the flat area of your hood between trim lines and body creases, then decide how much of it you want the pair to cover. A 4 or 8 inch pair reads as a subtle accent, while 12 and 18 inch widths give a bolder competition look. Leave room on both sides for the gap between the stripes.
When installed on a clean, intact factory-style paint surface and removed with gentle heat at a shallow angle, the vinyl lifts without aggressive scraping. Avoid applying over fresh or uncured paint, and avoid high-pressure washing directly at the stripe edges.
The air-release surface gives you some ability to lift and reset the stripe during the initial placement while the adhesive is fresh. Once squeegeed down firmly, treat it as set. Using tape as a hinge to preview placement before peeling the backing helps you get the alignment right the first time.
Not affiliated with or endorsed by the manufacturer. It is an independent aftermarket Vinyl Decal.
4 inch, 8 inch, 12 inch, 18 inch
Your shopping cart is empty
Notifications
