Flame Side Body Decal Set | Racing Decals for Trucks

Description

A two-sided flame graphic decal set that runs along your doors and fenders for a bold custom look. Choose a width from 12 to 48 inches to match your build.

Flame Graphics Built for Side Body Panels

This flame decal set is cut to dress up the sides of your vehicle, wrapping the visual flow from front fender through the doors. Each set includes mirrored left and right pieces so both sides match once installed. The flame tips are cut with clean edges so the design reads sharp from a distance, whether you park at a show or roll down the highway. Pick the width that fits your stance: smaller sets sit tight along the lower body line, while larger sets stretch across the doors for a fuller racing look. Because every build is different, measure your panel space before ordering so the flames land where you want them.

Matte, Gloss, Clear and Static Cling Options

Choose the finish that matches your paint and style. Matte flames sit flat against the surface and read like painted-on graphics, which works well on flat or low-gloss paint jobs. Gloss flames catch light along the edges and give a layered look over glossy paint. Clear vinyl offers a subtle tone-on-tone effect, while static cling lets you test placement or run flames for a season without adhesive. All options are printed on cast or calendered vinyl depending on the finish selected. If you are layering flames over existing racing decals, static cling is the easiest way to preview the layout before committing to a permanent set.

How to Install Your Flame Decal Set

Start with a clean, dry, wax-free surface; a wipe with isopropyl alcohol removes residue that weakens adhesion. Lay each flame piece in position with masking tape as a hinge, then peel the backing a section at a time while smoothing with a squeegee from the center outward. Work slowly around body lines and door handles, using gentle heat to help the vinyl conform to curves. Keep the vehicle dry for the first day after application. For static cling, skip the alcohol prep and simply press the piece onto a clean glass or smooth painted surface, smoothing out air as you go. Full instructions ship with every set.

Racing Decals for Show and Daily Drivers

Flame graphics have long been part of hot rod and motorsport culture, and this set brings that energy to modern trucks, Jeeps and daily drivers alike. They pair naturally with racing stripes, door numbers or a simple clean panel, letting you build a full theme over time. The set is cut to order, so each piece arrives fresh and ready to apply. Sold as a complete left and right pair in your choice of width from 12 to 48 inches. Fits Jeep Wrangler doors and similar side body panels. Not affiliated with or endorsed by the manufacturer.

What you get

• Mirrored left and right flame pieces in every set
• Width options from 12 to 48 inches
• Available in matte, gloss, clear and static cling finishes
• Printed on cast or calendered vinyl depending on finish
• Cut to order for fresh, ready-to-apply pieces
• Detailed installation instructions included
• Static cling option allows temporary or test placement

Specifications

Frequently asked questions

How do I choose the right width for my vehicle?

Measure the side panel area you want the flames to cover, from the front edge to where you want the tips to end. A 12-inch set sits along the lower body line, while larger widths stretch across doors and fenders for a fuller look.

Can I remove the flames later?

Yes. Warm the vinyl gently with a hair dryer or heat gun on low and peel it away slowly at a shallow angle. Any remaining adhesive can be cleaned off with isopropyl alcohol. Static cling pieces simply peel off with no residue.

Will these work over waxed paint?

Adhesive finishes bond best to clean, wax-free surfaces. Wipe the area with isopropyl alcohol before applying and keep the vehicle dry for the first day so the vinyl sets properly.