By vehicle
By style
By position
Guides
Marine & water
Powersports
Storefront & office
Labels & packaging
Bulk & wholesale
Send your own artwork
Upload your logo or sketch on any product page: we cut it in the width you choose.
Shop
Kids & anime
Sports & fan
Custom stickers
Start here
Your design, our vinyl
Send a sketch or logo, optional upload box sits under the size selector on every product.
Finishes we print
Sizes we cut
12"18"24"36"48"
Frosted-look stripe window decals that add privacy to office glass while keeping natural light. Sold as sets in widths from 12 to 48 inches, easy to apply and remove.
JPG, PNG, WEBP or PDF, up to 20 MB. Leave this empty to order the design shown above.
Open office layouts look great until every meeting is on display. These frosted stripe window decals soften the view through interior glass partitions, conference room doors, and sidelights, so people inside can work without feeling watched while the room still reads as bright and open. The stripe layout lets light pass through the clear bands while the frosted bands block a clear line of sight, which makes it a practical middle ground between bare glass and full blackout film. It is a simple upgrade for glass-walled offices, reception areas, clinics, salons, and home workspaces with French doors or glass panels. Choose the width that matches your glass and order as many sets as you need to cover the full run.
Each set is printed on cast vinyl with a matte frosted-look finish that reads like etched glass at a fraction of the cost of sandblasting. The stripes are cut with clean, consistent edges so the pattern lines up straight across your glass, and the material is thin enough to conform to flat panes without lifting at the borders. We print to order in our US shop, so every set leaves fresh rather than sitting in a warehouse. The decal applies to the interior side of the glass, which keeps it protected from weather and cleaning crews. Sizes run from 12 inches up to 48 inches wide, so you can dress a narrow sidelight or a wide conference wall with the same pattern.
Application takes a few minutes with basic tools: a spray bottle of soapy water, a squeegee or plastic card, and a utility knife for trimming. Clean the glass fully, mist it lightly, peel the backing, and position the decal while the surface is damp so you can slide it into place. Squeegee from the center outward to push out water and air, then trim any excess at the edges. Because the vinyl goes on with the wet method, you get a smooth, bubble-free result even on large pieces. It works on any smooth glass or smooth acrylic surface. If you reposition during installation, just re-wet and slide it before squeegeeing it down.
When your layout changes or your lease ends, the decal peels off interior glass in one piece in normal room conditions without scraping or harsh chemicals. Warm the surface slightly with a hair dryer if it has been in place a long time, then lift a corner and pull slowly at a low angle. Any leftover adhesive wipes away with glass cleaner. For daily upkeep, wipe with a soft cloth and standard glass cleaner, avoiding abrasive pads that could scratch the finish. Because it sits on the inside of the glass, the decal avoids sun, rain, and pressure washing entirely, which helps it keep its frosted appearance through regular office cleaning cycles.
No. The frosted bands diffuse the view while the clear stripe bands pass light straight through, so the room stays bright. It softens the glass rather than darkening it.
The frosted bands obscure a clear line of sight, so silhouettes and detail are hard to make out. For higher privacy, you can overlap or layer sets to reduce the clear stripe area.
They apply best to smooth glass or smooth acrylic. Heavily textured surfaces can trap air under the vinyl and keep the edges from laying flat, so we recommend smooth panes for the cleanest result.
12", 18", 24", 36", 48"
Your shopping cart is empty
Notifications
