By vehicle
By style
By position
Guides
Marine & water
Powersports
Storefront & office
Labels & packaging
Bulk & wholesale
Send your own artwork
Upload your logo or sketch on any product page: we cut it in the width you choose.
Shop
Kids & anime
Sports & fan
Custom stickers
Start here
Your design, our vinyl
Send a sketch or logo, optional upload box sits under the size selector on every product.
Finishes we print
Sizes we cut
12"18"24"36"48"
A pair of clear bubble-style vent decals cut from transparent vinyl, made for riders who want the look of helmet vents without painting or drilling. Sold in 4, 8, 12 or 18 inch decal sizes.
JPG, PNG, WEBP or PDF, up to 20 MB. Leave this empty to order the design shown above.
This pair of clear bubble vent decals gives any smooth helmet surface the appearance of molded air vents. The transparent vinyl catches light along the raised bubble edges, so the decals read as part of the shell rather than a printed Graphic. Because the finish is clear, the underlying helmet color shows through, which means one set works on black, white or bright-colored shells without clashing. Riders use them on full-face, open-face and half helmets, as well as on tanks, toolboxes and hard cases. Each order includes two matching decals, sized identically, so you can place them symmetrically on both sides of the helmet or stack them front and back.
These decals are sold by decal size, so pick the measurement that fits the flat area of your helmet before ordering. The 4 inch pair suits smaller shells or subtle accents near the chin bar. The 8 inch size is the most common choice for side placement on full-face helmets. The 12 inch pair works for oversized shells, motocross helmets or flat panels on luggage and fairings. The 18 inch option is intended for large surfaces such as tanks, trailers or garage doors. Measure the area with a tape measure first, since helmet curves reduce the usable flat space. When in doubt, choose the smaller size, as the bubble design stays crisp even at 4 inches.
Application takes a few minutes with household items. Clean the helmet with isopropyl alcohol and let it dry fully, since wax and dust keep vinyl from bonding. Peel the backing paper, position one decal, and press from the center outward to push air toward the edges. The clear carrier film lets you see the bubble outline as you place it, which helps with symmetrical alignment. Smooth the whole decal with a squeegee or the edge of a credit card, then peel the transfer tape slowly at a flat angle. Repeat with the second decal, checking alignment against the first. Avoid stretching the vinyl over sharp compound curves; the bubbles look best on gently curved or flat areas.
Once applied, these decals handle the conditions riders expect: sun, wind, road spray and light rain. Wash the helmet by hand with mild soap and a soft cloth rather than abrasive cleaners or pressure washers, both of which can lift the edges. Skip scrubbing directly over the bubble lines. If you ride in cold weather, let the helmet reach room temperature before washing. Should you want to remove or reposition the pair later, warm the vinyl gently with a hair dryer on low and peel slowly; any remaining adhesive comes off with isopropyl alcohol. With reasonable care, the clear finish stays readable and the edges stay down through regular riding seasons.
Yes, on gently curved areas. The vinyl conforms to smooth curves, but avoid stretching it over sharp compound curves like chin bar edges, as that can lift the bubble outlines. Flat or mildly curved side panels give the cleanest result.
The 8 inch pair is the most common fit for side placement on full-face helmets. Measure the flat area of your shell first, and if you are between sizes, choose the smaller one since the design stays crisp at 4 inches.
Yes. They are cut from clear vinyl with no background, so your helmet's color shows through the decal. Only the bubble vent outlines themselves are visible once applied.
4 inch, 8 inch, 12 inch, 18 inch
Your shopping cart is empty
Notifications
