By vehicle
By style
By position
Guides
Marine & water
Powersports
Storefront & office
Labels & packaging
Bulk & wholesale
Send your own artwork
Upload your logo or sketch on any product page: we cut it in the width you choose.
Shop
Kids & anime
Sports & fan
Custom stickers
Start here
Your design, our vinyl
Send a sketch or logo, optional upload box sits under the size selector on every product.
Finishes we print
Sizes we cut
12"18"24"36"48"
A matte and gloss carbon-look stripe decal kit for Nissan Altima owners who want a custom two-tone accent along the body panels. Cut from Cast Vinyl in your choice of four decal sizes.
JPG, PNG, WEBP or PDF, up to 20 MB. Leave this empty to order the design shown above.
This stripe kit is designed for Nissan Altima sedans and gives the doors, hood or rear quarter panels a layered racing-style accent without paint. Each stripe is cut from Cast Vinyl and available in matte or gloss finishes, so you can match a factory paint tone or create contrast. Choose decal sizes of 4, 8, 12 or 18 inches depending on how bold you want the layout to appear. The kit works well for daily drivers, show builds and weekend projects alike. Not affiliated with or endorsed by the manufacturer. Pair it with other pieces from our Nissan Titan decals collection page if you are outfitting more than one vehicle in the household.
Every stripe in this kit is offered in a matte or gloss finish. Matte gives a low-key, muted contrast that reads well against darker paint, while gloss catches light and sits closer to a painted pinstripe. Both finishes are printed on Cast Vinyl that conforms to the gentle body curves of a modern sedan. There are no special tools required beyond a squeegee or soft card and a little soapy water for positioning. Because the stripes are die-cut, the edges stay crisp after installation, and the vinyl can be repositioned during application while the surface is still wet. Take your time aligning the first stripe and use it as the guide for the rest.
Start with a clean, dry surface at moderate room temperature. Wash the panels thoroughly, remove any wax residue with isopropyl alcohol, and let the area dry completely. Lay each stripe lightly with a soap-and-water slip solution so you can slide it into position before squeegeeing it down. Work from the center outward to push moisture out and avoid trapping air. Smaller 4 and 8 inch decals are a good entry point if you are new to vinyl, while the 12 and 18 inch sizes cover more panel area in a single piece. Wait about 24 to 48 hours before washing the car so the adhesive sets fully.
When you are ready for a change, warm the stripes gently with a hair dryer on low heat and peel them back slowly at a shallow angle. Cast Vinyl typically releases cleanly from well-maintained paint without leaving residue behind; any leftover adhesive can be rolled off with a fingertip or removed with a mild adhesive remover. For everyday care, hand washing is gentler than automatic brush washes, and avoiding direct pressure wash sprays at the stripe edges helps them stay down. Avoid waxing directly over the decals. With reasonable care, the kit keeps its look through regular driving and seasonal weather.
The kit is sized for Nissan Altima sedans and comes in 4, 8, 12 or 18 inch decal sizes so you can scale the layout to your panels. Not affiliated with or endorsed by the manufacturer. Measure your application area before ordering to confirm the size you prefer.
Yes. The vinyl can be applied wet with a soap-and-water slip solution, which lets you slide each stripe into position before squeegeeing it down. A squeegee or soft card and some masking tape for alignment are all the tools you need.
On well-maintained, original paint, warming the vinyl with low heat and peeling slowly typically removes it without residue. Any leftover adhesive can be lifted with a mild adhesive remover. Test on an inconspicuous spot first if your paint is older or repainted.
4 inch, 8 inch, 12 inch, 18 inch
Your shopping cart is empty
Notifications
