By vehicle
By style
By position
Guides
Marine & water
Powersports
Storefront & office
Labels & packaging
Bulk & wholesale
Send your own artwork
Upload your logo or sketch on any product page: we cut it in the width you choose.
Shop
Kids & anime
Sports & fan
Custom stickers
Start here
Your design, our vinyl
Send a sketch or logo, optional upload box sits under the size selector on every product.
Finishes we print
Sizes we cut
12"18"24"36"48"
A pair of dual racing stripe decals cut from gloss Cast Vinyl, sized for car hoods, trunks and roof panels. Made for drivers who want a clean stripe look without a full wrap.
JPG, PNG, WEBP or PDF, up to 20 MB. Leave this empty to order the design shown above.
This kit includes two parallel stripe decals that run side by side to create the classic dual racing stripe look. Each stripe is cut individually so you can set your own gap width and trim the ends to match your body lines. Choose the stripe height that fits your build: 4 inch stripes work well on smaller panels, 8 inch is a popular middle ground, 12 inch fills out a hood with a bolder stance, and 18 inch makes a strong statement across a roof or trunk. The kit ships with application tape already applied, so the pair lifts off the backing as one piece per stripe and goes down in a single pass.
The stripes are printed and cut on gloss Cast Vinyl, a flexible film that conforms to gentle curves, panel edges and body seams without lifting at the corners. The gloss finish catches light similar to a clear-coated paint surface, which helps the stripes blend in rather than sit on top of the paint. Cast Vinyl also resists shrinking and pulling over time better than thicker calendered films, so edges stay put through sun, rain and car washes. Application is a dry or wet install with standard squeegee technique, and the material can be repositioned during placement before you firm it down along the edges.
Start with a clean, dry surface free of wax and polish residue, since any film left on the paint weakens adhesion. Lay each stripe in position with light tack first, confirm the gap and alignment from several viewing angles, then squeegee from the center outward to push air toward the edges. On warm days the vinyl stretches slightly around curves; on cold days warm the panel and the film before working complex areas. Trim excess at panel gaps with a sharp blade guided by the body line. Full install for a pair of stripes typically takes an afternoon for a first-timer, faster with a helper holding alignment.
Dual stripes work as a standalone statement or as the anchor for a larger build. Many buyers add a hood stripe set, side graphics or a rear window decal in the same gloss finish to keep the look consistent across the vehicle. Because the stripes are sold by height, you can mix sizes, for example an 18 inch pair on the roof with 8 inch accents on the mirrors or trunk. If you want the stripe look for a show, event or seasonal change, ask about our static cling option, which applies without adhesive and peels off cleanly when the weekend is over.
Measure the panel you plan to stripe first. A 4 or 8 inch pair suits hoods and trunks on smaller sedans, while 12 or 18 inch stripes fill larger roofs and hoods with a bolder look. You can also mix sizes across different panels.
Yes. The stripes ship pre-masked, so each one applies as a single piece. Clean the surface, position with light tack, check alignment, then squeegee from the center outward. A second pair of hands helps with longer stripes.
Applied to factory or cured paint in good condition, the vinyl removes by peeling at an angle, ideally with gentle heat. Avoid installing on fresh or uncured paint, and test in a small area if you are unsure.
Not affiliated with or endorsed by the manufacturer. It is an independent aftermarket Vinyl Decal.
4 inch, 8 inch, 12 inch, 18 inch
Your shopping cart is empty
Notifications
