Camouflage Truck Hood Decals | Matte Vinyl Wrap Kit

Description

A camouflage hood decal set printed on cast vinyl, sized to fit truck hoods from 12 to 48 inches wide. For truck owners who want a rugged field look without a full wrap.

Camouflage Hood Decals Built for Working Trucks

This truck hood decal set brings classic camo coverage to the most visible panel on your vehicle. Each set is cut to your chosen width, from 12 inches up to 48 inches, so you can cover the full hood or run a smaller panel accent on the leading edge. The camouflage pattern is printed on cast vinyl with a matte finish that reads like fabric rather than plastic, which helps it blend with bed liners, toolboxes, and trail gear. Whether your truck lives on a job site, a hunting lease, or just dusty back roads, this is a simple way to change the look of the front end in an afternoon without committing to paint or a full-body wrap.

Choose Your Width and Coverage

Every order ships as a set sized to your selection. The 12-inch and 18-inch options work well as hood accents or leading-edge stripes, while the 36-inch and 48-inch sizes cover most full truck hoods on standard half-ton and heavy-duty cabs. Measure the flat area of your hood between the fender lines before ordering, and pick the width that matches. Because the vinyl is cut to width rather than pre-shaped for one specific hood, you trim the final fit at the edges during installation with a hobby knife or scissors. This makes the set a flexible choice if you plan to move it to a different truck later or layer it with other body panel decals.

Matte, Gloss, and Clear Finish Options

We print this camo pattern in three finishes. Matte is the most popular pick for hunting and off-road use because it cuts glare and matches the flat look of factory trail packages. Gloss gives the pattern a deeper, wetter look that stands out against flat paint. Clear is printed on transparent vinyl so the camo shapes sit over your paint color, letting your truck's original tone show through the open areas of the pattern. All three are the same cast vinyl base, so the choice is purely about appearance. Static cling is not offered on this set because hood placement faces direct airflow and pressure at highway speed.

Installing Your Hood Decal Set

Installation takes a clean hood, a spray bottle with soapy water, and a squeegee or soft card. Wash the hood and remove any wax so the adhesive bonds evenly. Lay each panel dry first to confirm placement, then wet the surface, peel the backing, and float the decal into position. Squeegee from the center outward to push water and air to the edges, then let it sit before trimming. Park in the shade and avoid washing for the first day or two so the adhesive sets. When you are ready for a change, warm the vinyl with a hair dryer and peel it away slowly, working residue off with an adhesive-safe cleaner.

What you get

• Camouflage pattern printed on cast vinyl for contouring over hood curves
• Available in matte, gloss, and clear finishes
• Sold as a set with width options from 12 to 48 inches
• Trim-to-fit edges suit most truck hood widths
• Wet-install application with soapy water for repositioning during placement
• Removable with heat without paint damage when installed on factory-finish paint
• Printed in our US shop to order

Specifications

Frequently asked questions

How do I pick the right width for my truck?

Measure the flat hood area between the fender lines at the widest point and choose the closest width. If you are between sizes, go smaller and trim to fit during installation.

Will this damage my paint?

When applied to clean factory-finish paint and removed with heat, the decal lifts away without pulling paint. Avoid installing on fresh or repainted panels that have not fully cured.

Can I wash my truck normally after installing?

Wait about 48 hours after installation before washing so the adhesive fully bonds. After that, hand washing and touchless car washes are fine; avoid high-pressure sprayers directly on the edges.