Skulls Tailgate Wrap Decal for Trucks | Cast Vinyl

Description

A full skull-pattern tailgate wrap printed on cast vinyl, made for truck owners who want a bold custom look across the back of their rig. Available in widths from 12 to 48 inches.

Skull Tailgate Wrap That Fills the Back of Your Truck

This skulls truck tailgate wrap turns the flattest real estate on your vehicle into the loudest part of it. The artwork is printed as one continuous wrap, so the pattern flows edge to edge without awkward seams or visible breaks. It is cut to your chosen width, from a compact 12-inch accent up to a full 48-inch spread that covers most tailgates. The design suits lifted trucks, work trucks, and weekend rigs alike, and it reads clearly from a distance, which is the whole point of putting it back there. If you have been browsing tailgate decals and want something with more presence than a single small sticker, this wrap is the step up.

Printed on Cast Vinyl in Matte or Gloss

Every wrap is printed on cast vinyl, the conformable film that bends around gentle curves, panel ridges, and handle recesses without lifting at the edges. You choose the finish: matte for a low-sheen, tattooed look that hides fingerprints and water spots, or gloss for a shiny, freshly detailed finish that makes the skull artwork pop in sunlight. Both finishes are printed with inks that lay down rich blacks and crisp detail straight off the press. The vinyl is a film made for outdoor use, so rain, road spray, and car washes are part of normal life for the graphic.

How to Install Your Tailgate Wrap

Installation is a single-person job with a little patience. Clean the tailgate with isopropyl alcohol and let it dry completely. Peel the backing, position the wrap starting from one edge, and smooth it across using a felt-edge squeegee or the edge of a credit card, working outward to push air toward the open side. The cast vinyl has enough give to stretch around curves, and small bubbles can be lifted and re-laid while the adhesive is fresh. Park in the shade and avoid washing the truck for the first 48 hours so the adhesive bonds fully. Full removal later is done with heat from a hair dryer or heat gun, peeling at a low angle.

Choosing Your Width and Finish

Measure the flat area of your tailgate before ordering, and pick the width that fits inside the panel edges and around the handle. A 12- or 18-inch width works well as a centered accent, 24 to 36 inches covers most standard tailgates, and 48 inches suits wide or dually-style rear ends. Each order is a complete set: the printed wrap, a transfer layer that keeps the design aligned during application, and illustrated instructions. If you are between sizes, going slightly smaller than your measured area makes installation more forgiving. Matte and gloss are both available at every width, so the finish choice comes down purely to the look you want.

What you get

• Continuous skull-pattern wrap printed as one piece, no seams
• Available in widths from 12 to 48 inches
• Choice of matte or gloss cast vinyl finish
• Cast vinyl conforms to curves, ridges, and handle recesses
• Printed with inks designed for use on vinyl stickers
• Outdoor-rated adhesive stands up to rain and car washes
• Set includes wrap, transfer layer, and instructions

Specifications

Frequently asked questions

Will one size fit every truck?

No. Tailgates vary in width and shape, so we offer widths from 12 to 48 inches. Measure the flat area of your tailgate and choose the width that fits within those measurements.

Can I remove the wrap later?

Yes. Warm the vinyl with a hair dryer or heat gun and peel it off at a low angle. Any remaining adhesive residue can be cleaned with isopropyl alcohol.

Will it survive car washes?

The cast vinyl and outdoor-rated adhesive are made for normal washing and weather. Avoid high-pressure spray directly at the edges of the wrap, especially in the first 48 hours after installation.