Checkers & Dragons Wave Truck Decal Half Wrap Kit

Description

A checkered and dragon wave half wrap graphic kit for pickup trucks, printed on cast vinyl and cut to fit both sides of your bed. Sold as a mirrored set with widths from 12 to 48 inches.

A Checkered Dragon Wave Design for Your Truck

This half wrap graphic pairs a flowing wave line with a checkered band and a stylized dragon accent, giving your pickup a layered, custom-painted look without the paint shop. The design runs along the lower body line of the truck bed, so it reads as part of the vehicle rather than a sticker slapped on top. It works on flat and gently curved panels, and the mirrored layout means both sides of the truck get the same forward-facing flow. If you have been browsing truck decals for something bolder than a single small emblem, this kit is built for that gap between a bumper sticker and a full wrap.

Choose Your Width from 12 to 48 Inches

Every truck sits a little differently, so this graphic is sold in width options from 12 inches up to 48 inches. Measure the flat area of your bed panel where you plan to place the design, then pick the width that covers it without wrapping past body lines. Smaller widths suit compact trucks and accent placement behind the rear wheel; the larger sizes fill the side of a full-size bed. Because the set is cut to the selected width, take your time with a tape measure before ordering. The height scales with the width, keeping the wave and checker proportions consistent across every size.

Matte, Gloss, Static Cling or Clear Finishes

The kit is printed in your choice of matte or gloss cast vinyl for a long-term installed look, static cling for a temporary display you can reposition and remove by hand, or clear vinyl when you want the graphic to sit subtly over the paint. Matte softens the design into the body work; gloss gives it a wet, painted shine. Cast vinyl conforms to the gentle curves along a truck bed better than thicker films, which helps edges lay down flat. Application is a dry process: clean the panel, peel the backing, position the graphic, and squeegee from the center outward, following the included instructions.

Care, Removal and Ordering Details

Once installed, wash the graphic along with the truck using mild soap and a soft cloth, and avoid high-pressure spray directly at the edges. For removal, warm the vinyl gently and peel it away at a shallow angle; static cling versions simply lift off with no residue. Each order includes the left and right side graphics as a mirrored pair, an application squeegee, and illustrated instructions. Because every set is printed and cut to your chosen width after you order, check your measurements carefully and reach out with questions about placement before purchasing. This kit is a decorative graphic and is not a substitute for protective film.

What you get

• Mirrored left and right side set for a balanced look on both truck bed panels
• Available in widths from 12 to 48 inches to fit compact and full-size trucks
• Printed on cast vinyl in matte or gloss, or choose static cling or clear
• Dragon wave and checker design scaled proportionally at every size
• Dry application with included squeegee and illustrated instructions
• Static cling option removes by hand with no residue

Specifications

Frequently asked questions

Will this fit my specific truck model?

The graphic is sold by width rather than by vehicle model, so it is not a model-specific fit. Measure the flat area of your bed panel and choose the width that matches, from 12 to 48 inches.

What is the difference between the vinyl and static cling versions?

The cast vinyl versions are applied permanently and hold up as an installed graphic, while static cling attaches without adhesive so you can remove and reposition it by hand at any time.

Can I install this myself?

Yes. The kit applies dry using the included squeegee and instructions. Work on a clean panel in moderate temperatures and smooth from the center outward to push air out toward the edges.