By vehicle
By style
By position
Guides
Marine & water
Powersports
Storefront & office
Labels & packaging
Bulk & wholesale
Send your own artwork
Upload your logo or sketch on any product page: we cut it in the width you choose.
Shop
Kids & anime
Sports & fan
Custom stickers
Start here
Your design, our vinyl
Send a sketch or logo, optional upload box sits under the size selector on every product.
Finishes we print
Sizes we cut
12"18"24"36"48"
A pair of gloss black dual racing stripes cut from Cast Vinyl, sized to run the length of your SUV's hood and roof. Made for drivers who want a classic track-inspired look without paint.
JPG, PNG, WEBP or PDF, up to 20 MB. Leave this empty to order the design shown above.
Racing stripes have been part of American car culture for decades, and this dual stripe decal set brings that look to your 4Runner in a clean gloss black finish. Each kit contains two parallel stripes cut from Cast Vinyl, designed to follow the centerline of the hood, roof, or full body length. The gloss surface catches light the way painted pinstripes do, giving the appearance of a factory-style accent at a fraction of the cost of a paint visit. Whether you drive a trail rig or a daily commuter, this is one of the simplest upgrades in our Toyota racing stripes collection to install and enjoy.
Every build is different, so these stripes are offered in four decal widths. The 4 inch set is a subtle, pinstripe-style accent that suits owners who want a hint of contrast. The 8 and 12 inch options are the most popular middle ground, wide enough to read clearly from across a parking lot without overwhelming the body lines. The 18 inch set makes a bold statement, covering a large portion of the hood and roof for a muscle-car-inspired presence. All widths come as a matched pair with even spacing between the two stripes, so the layout looks intentional and balanced from every angle.
The vinyl is cut with a weeded design and premasked transfer tape, so both stripes go down as one aligned unit instead of two separate pieces you have to measure yourself. Cast Vinyl conforms to gentle curves and body contours, which matters on hoods with ridges or slightly crowned roof panels. Application works best on a clean, wax-free surface above roughly 60 degrees Fahrenheit, using the wet or dry method of your choice. Take your time squeegeeing from the center outward, and the stripes will lay flat without trapped air. A friend to help align longer runs is recommended.
Once applied, the stripes can be washed normally by hand; avoid direct pressure washing at the stripe edges and skip automated brush washes, which can lift corners over time. When you are ready for a change, warm the vinyl with a hair dryer or heat gun on low and peel it away slowly, working adhesive residue off with an adhesive remover safe for automotive paint. Each order includes the dual stripe pair, transfer tape, and illustrated installation instructions. Measure your hood and roof width before ordering to confirm which of the four sizes fits your build best, since widths are cut to the listed dimensions.
The stripes arrive cut to the width you select and can be trimmed to length during installation. Most owners trim the ends at the hood edge or windshield line with a sharp blade after the vinyl is laid down.
Vinyl adheres best when the surface and air are above roughly 60 degrees Fahrenheit. In cooler conditions, work in a heated garage or warm the surface slightly before applying.
When warmed with a hair dryer and peeled slowly, the vinyl removes cleanly from factory paint in good condition. Avoid pulling cold vinyl aggressively, and test in a small area first.
Not affiliated with or endorsed by the manufacturer. It is an independent aftermarket Vinyl Decal.
4 inch, 8 inch, 12 inch, 18 inch
Your shopping cart is empty
Notifications
