By vehicle
By style
By position
Guides
Marine & water
Powersports
Storefront & office
Labels & packaging
Bulk & wholesale
Send your own artwork
Upload your logo or sketch on any product page: we cut it in the width you choose.
Shop
Kids & anime
Sports & fan
Custom stickers
Start here
Your design, our vinyl
Send a sketch or logo, optional upload box sits under the size selector on every product.
Finishes we print
Sizes we cut
12"18"24"36"48"
A gloss black vinyl tailgate decal kit for Ram truck owners who want a clean, layered blackout look. Available in 4, 8, 12 or 18 inch decal sizes to fit your build.
JPG, PNG, WEBP or PDF, up to 20 MB. Leave this empty to order the design shown above.
This gloss black tailgate decal kit is cut for truck owners who want the blackout treatment without the cost of paint or plasti-dip. The layered design follows the natural lines of a full-size pickup tailgate, filling the recessed panels with a deep gloss finish that reads like factory trim from a distance. Whether you are pairing it with dodge racing stripes down the bed or running it on its own, the kit gives the back of the truck a finished, intentional look. Choose the decal size that matches your tailgate layout, apply it in your driveway, and enjoy a styling upgrade that takes an afternoon, not a weekend.
Each piece is printed and cut on Cast Vinyl, the conformable material that handles the curves and recesses of a truck tailgate better than cheaper flat films. The gloss black finish resists fading in direct sun and holds up to rain, road grime and routine washes. There is no ink layer to scratch off the surface, so the black stays black. The kit ships with application tape already in place, so the graphics stay aligned as you lay them down. With basic tools, a spray bottle of soapy water and a squeegee, most truck owners get a smooth, bubble-free install in under an hour.
Decal size is the single biggest decision with this kit, and it comes down to the look you want. The 4 inch set is a subtle accent for owners who want a hint of blackout trim. The 8 and 12 inch sizes are the most popular middle ground, filling the tailgate panels without overwhelming the truck. The 18 inch set makes a bolder statement and works best on trucks already carrying other exterior mods. Before ordering, measure the flat areas of your tailgate with a tape measure and compare against the listed decal dimensions. When in doubt, size down slightly, since a slightly smaller decal is far easier to position than one that is too large.
Start with a clean, dry tailgate, ideally applied when temperatures are moderate and out of direct hot sunlight. Use the soapy water method for positioning, then squeegee from the center outward to push water and air to the edges. Wait a full day before washing the truck so the adhesive fully bonds. For ongoing care, skip high-pressure wands aimed directly at the decal edges and use a mild car shampoo instead. If you ever want to remove the kit, warm the vinyl gently with a hair dryer and peel it away slowly. Any remaining adhesive cleans up with a citrus-based remover, leaving the paint underneath ready for whatever you run next.
The kit is sold by decal size rather than by model year. Measure the flat areas of your tailgate and compare against the 4, 8, 12 or 18 inch options to choose the best fit. We do not claim exact factory fitment for any specific truck.
Cast Vinyl is an outdoor-rated material, and many customers run it for years of daily driving. Actual longevity depends on your climate, washing habits and sun exposure, so we do not publish a specific service life figure.
Yes. The gloss black finish matches our stripe kits, so you can run the tailgate kit on its own or combine it with stripes along the bed for a coordinated blackout build.
Not affiliated with or endorsed by the manufacturer. It is an independent aftermarket Vinyl Decal.
4 inch, 8 inch, 12 inch, 18 inch
Your shopping cart is empty
Notifications
