By vehicle
By style
By position
Guides
Marine & water
Powersports
Storefront & office
Labels & packaging
Bulk & wholesale
Send your own artwork
Upload your logo or sketch on any product page: we cut it in the width you choose.
Shop
Kids & anime
Sports & fan
Custom stickers
Start here
Your design, our vinyl
Send a sketch or logo, optional upload box sits under the size selector on every product.
Finishes we print
Sizes we cut
12"18"24"36"48"
A four-piece matte Vinyl Decal pack designed for truck windows, tailgates, toolboxes and smooth body panels. Cut from matte Cast Vinyl for a clean, painted-on look on any Ram truck build.
JPG, PNG, WEBP or PDF, up to 20 MB. Leave this empty to order the design shown above.
This pack of four matte vinyl decals is made for truck owners who want graphics without the shine. The matte finish absorbs light instead of reflecting it, so each decal blends into glass and painted surfaces like it was airbrushed on. Each piece is cut from matte Cast Vinyl that conforms to the gentle curves of a window or tailgate without lifting at the edges. Apply one decal per window, stack the set across a rear glass, or split them between your truck and your toolbox. The solid black matte cut reads bold up close and clean from a distance, which makes it a favorite for daily drivers and show builds alike. Every decal arrives pre-masked and ready to position with transfer tape.
Choose the size that matches where you plan to install. The 4 inch decals suit side mirrors, corner glass and small toolbox lids. The 8 inch size works well on rear side windows and lower door panels. The 12 inch decals fill a rear quarter window or the flat center of a tailgate. The 18 inch option is built for full rear glass or across a bed rail. All four decals in a pack ship at the same selected size, so you can run a matching set across every window. Measure your glass before ordering and leave a little clearance around edges and defroster lines for the cleanest install.
This decal pack is one piece of our broader ram & dodge charger decals collection, which covers window graphics, tailgate lettering and body decals for truck and muscle car builds. If you want to mix this matte set with gloss or clear finish decals from the same collection, the finishes are designed to sit next to each other without clashing. Matte pairs especially well with dark paint and tinted glass, where gloss decals would catch glare. Browse the collection to build a coordinated look across your windows, or keep it simple with this single four-piece set and a clean, understated finish.
Installation takes only a few minutes per decal with basic tools. Clean the surface with isopropyl alcohol and let it dry fully. Peel the paper backing, position the decal using the transfer tape as a carrier, and press from the center outward with a squeegee or credit card. Slowly peel the tape back at a low angle, leaving the matte vinyl flat on the glass. Work in moderate temperatures and avoid applying in direct sun or extreme cold. For curved glass, warm the decal slightly with a hair dryer so the Cast Vinyl stretches into place. Bubbles can be smoothed out or pierced with a pin and pressed flat.
Yes. Each pack contains four matching decals in the size you select at checkout, either 4, 8, 12 or 18 inches. If you want multiple sizes, order one pack per size.
Matte black vinyl blends especially well with tinted glass because it does not reflect light the way gloss decals do. The result is a subtle, painted-on appearance from both inside and outside the vehicle.
Yes. Warm the decal gently with a hair dryer and peel it away slowly at a low angle. Any remaining adhesive can be cleaned off with isopropyl alcohol. Removal is easiest in moderate temperatures.
Not affiliated with or endorsed by the manufacturer. It is an independent aftermarket Vinyl Decal.
4 inch, 8 inch, 12 inch, 18 inch
Your shopping cart is empty
Notifications
