By vehicle
By style
By position
Guides
Marine & water
Powersports
Storefront & office
Labels & packaging
Bulk & wholesale
Send your own artwork
Upload your logo or sketch on any product page: we cut it in the width you choose.
Shop
Kids & anime
Sports & fan
Custom stickers
Start here
Your design, our vinyl
Send a sketch or logo, optional upload box sits under the size selector on every product.
Finishes we print
Sizes we cut
12"18"24"36"48"
A set of two checkered flag stripe decals cut from cast vinyl, made for boat owners who want a racing look on the hull. Choose your width from 12 to 48 inches to fit your ride.
JPG, PNG, WEBP or PDF, up to 20 MB. Leave this empty to order the design shown above.
This two-piece decal set brings the classic checkered flag pattern to your hull, transom, or cowling in a clean stripe layout. Each stripe is cut individually so you can space the pair to match your boat's lines, whether you run them along the gunwale, across the transom, or down the sides of a bass boat or pontoon. The checkered pattern is printed in high-contrast black and white, the look most associated with checkered flag finishes and race day. Because the set is sold as a matched pair, both sides of your boat get the same cut, so the pattern lines up evenly port and starboard when installed with care.
The set is offered in widths from 12 inches up to 48 inches, measured across the widest point of each stripe. Narrower widths suit smaller craft, console doors, cooler lids, and trailers, while the larger sizes are cut to stretch along the hull of bigger boats. Before ordering, measure the flat area where you plan to apply the decals and compare it to the listed width of the size you select. Vinyl conforms best to gentle curves, so pick a mounting spot with minimal rivets, steps, or hardware. If you are layering the pair with other graphics, leave a small gap between elements so each stripe can be smoothed down without trapping air along the edges.
Each stripe is cut from cast vinyl, a thin, flexible film that follows the curves of a hull better than thicker materials. Choose a matte finish for a low-sheen painted look, a gloss finish for shine that reads from a distance, or a clear option when you want the checkered pattern to sit subtly over your boat's base color. The vinyl resists fading from sun exposure and holds up to routine washing, trailering, and time on the water. Application is a standard wet or dry install with transfer tape, and the decals can be removed with heat when you want a change. Full surface prep and installation steps are included with every order.
Every set is printed and cut to order in our shop, so your custom racing stripes ship fresh rather than sitting in warehouse inventory. If you need a width outside the listed range, a different colorway, or a mirrored layout for a specific hull, message us before ordering and we will let you know what is possible. Boats vary widely in shape and hardware placement, so we encourage measuring twice and reaching out with questions. Each order includes both stripes, transfer tape, a squeegee card, and illustrated instructions so you have what you need for a clean install at the dock or in the driveway.
Measure the flat area where each stripe will go, at its widest point, and choose the size that fits within that space. The 12-18 inch widths work well on smaller craft and accents, while 36-48 inch sizes suit full-length hull stripes.
The cast vinyl is made for exterior marine use and resists sun fading, washdowns, and normal trailering. Avoid high-pressure spraying directly at the stripe edges and allow the adhesive to cure before your first launch after installing.
Yes, we cut every set to order. Message us with your color or size request and we will confirm what we can do before you purchase.
12", 18", 24", 36", 48"
There are no reviews yet.
You must be logged in to post a review.
Your shopping cart is empty
Notifications
