Double Racing Stripe Vinyl Decal Pair for Cars & Trucks

Description

A pair of matching dual racing stripe decals cut from cast vinyl, sized to run down the hood, roof, or body panels of your car, truck, or SUV. Made to order in our shop for drivers who want a classic motorsport look.

Classic Dual Racing Stripes, Cut to Your Width

This decal pair delivers the timeless twin-stripe motorsport look in a clean, do-it-yourself format. Each order includes two matching stripe decals, so you can run them down the center of your hood and roof, along the doors, or across a tailgate. Choose your total width from 12 to 48 inches, and we cut the pair to that spec before it ships. The stripes are printed and contour-cut on cast vinyl in your choice of matte, gloss, or clear finish, with a static cling option if you want a temporary look. Because the pair is cut to order, the proportions stay balanced whether you drive a compact coupe, a full-size pickup, or anything between.

How Our Racing Decals Are Made

Every stripe pair is produced in our shop on cast vinyl, a thin, conformable film that follows gentle body curves better than thicker calendered material. We cut each stripe with clean edges so the line stays crisp from a few feet away and up close. The finish is up to you: matte for a low-key, painted-on look, gloss for a bold contrast against flat paint, clear for a subtle tone-on-tone effect, or static cling for a peel-off application with no adhesive. Inks are laid down for solid, even color across the full length of each stripe. No two pairs leave the shop without being checked against your selected width.

Installing Your Stripe Pair

Application is a wet or dry process with transfer tape, and the stripes arrive ready to position. Start with a clean, dry, wax-free surface and a moderate-temperature day. Lay out both stripes and check spacing against the centerline of the panel before removing any backing. Once placed, squeegee from the center outward to push out air and moisture, then peel the tape at a low angle. The cast vinyl conforms to mild curves and panel breaks, and a little heat from a hair dryer helps it settle around edges. Full step-by-step instructions ship with every pair, so first-time installers can work at a comfortable pace.

Sizing, Care, and Ordering

Width options run from 12 to 48 inches, measured across the full pair. A 12-inch pair suits motorcycles, scooters, and small hatches; 24 to 36 inches fits most sedans, coupes, and crossovers; 48 inches covers trucks, vans, and wide hoods. Before ordering, measure the area you want to cover and compare it to the listed width. For care, hand wash gently and avoid high-pressure sprays directly on the stripe edges. If you want to remove the pair later, warm it gently and peel slowly. Static cling versions remove clean with no residue, making them a good pick for leased vehicles or seasonal looks.

What you get

• Sold as a matching pair of two dual racing stripe decals
• Width options from 12 inches to 48 inches across the pair
• Cut from cast vinyl for a thin, conformable fit on curved panels
• Available in matte, gloss, clear, or static cling finishes
• Contour-cut edges for a crisp, straight stripe line
• Ships with transfer tape and step-by-step installation instructions
• Made to order in our US shop

Specifications

Frequently asked questions

How do I choose the right width for my vehicle?

Measure the area you want the stripes to cover, such as the width of your hood or tailgate, and choose the option closest to that measurement. The listed size is the total width across both stripes in the pair.

Will the stripes work on curved panels?

Yes. The pair is cut from cast vinyl, a thin and conformable film that follows gentle body curves. A little heat during installation helps it settle around edges and panel breaks.

Can I remove the stripes later?

Yes. Warm the vinyl gently with a hair dryer and peel slowly. Static cling versions remove clean with no adhesive residue, which makes them a good option for leased vehicles.