By vehicle
By style
By position
Guides
Marine & water
Powersports
Storefront & office
Labels & packaging
Bulk & wholesale
Send your own artwork
Upload your logo or sketch on any product page: we cut it in the width you choose.
Shop
Kids & anime
Sports & fan
Custom stickers
Start here
Your design, our vinyl
Send a sketch or logo, optional upload box sits under the size selector on every product.
Finishes we print
Sizes we cut
12"18"24"36"48"
A cut vinyl flame graphic set sized for car hoods, available in widths from 12 to 48 inches. Made for drivers who want a bold flame look without a full wrap.
JPG, PNG, WEBP or PDF, up to 20 MB. Leave this empty to order the design shown above.
This flame decal set brings classic hot rod styling to your hood in a way that works with almost any paint color. Each set is cut from cast vinyl and sized to your chosen width, so you can run a subtle 12-inch pair along the front edge or stretch a full 48-inch layout across the hood. The flames are cut as individual graphics rather than printed, which keeps the edges crisp and lets your paint show through the negative space. Apply the pair mirrored on both sides for a symmetrical look, or trim and place a single side for an off-center accent. It is a straightforward way to add car graphics that read as custom work at a fraction of a paint job.
Every flame set is offered in matte, gloss, clear, and static cling finishes, so you can match the sheen of your vehicle's paint or go for contrast. Matte flames sit low-key against gloss paint, while gloss vinyl blends in and reads like painted pinstriping. Clear finishes work well over darker hoods where you want a ghost flame effect, and static cling gives you a temporary option you can reposition or remove whenever you like. Widths run from 12 to 48 inches, measured across the widest point of each flame panel. Pick the size that matches your hood's proportions, and trim excess material with a hobby knife after application for a clean edge.
Application takes patience but no special tools beyond a squeegee or credit card and some masking tape. Start by cleaning the hood with isopropyl alcohol and letting it dry fully, since wax and dust are the main causes of lifting edges. Position each flame with masking tape hinges, check the symmetry from a few steps back, then peel the backing and squeegee from the center outward. Work slowly on curves and creases, letting the vinyl warm slightly in the sun or with a hair dryer so it conforms. Finish by peeling the transfer tape at a shallow angle. Avoid washing the car for the first couple of days so the adhesive sets fully.
Once applied, the flames handle normal hand washing and weather the same as any quality vinyl graphic. Skip pressure washing directly at the edges, and avoid automated brush washes, which can catch a lifted corner. When you are ready for a change, warm the vinyl with a hair dryer and peel it back slowly at a low angle; any leftover adhesive generally comes off with rubbing alcohol. If you want to refresh the look later or try a different finish, reorder the same set in a new width or color scheme. Each set ships with both left and right flame panels, transfer tape, and illustrated instructions so you have everything needed for the job.
The graphics are trim-friendly, so you can cut or overlap sections to follow your hood's contours. Widths from 12 to 48 inches cover everything from a small accent to a full hood layout, and you can position the flames wherever they look best.
Clear vinyl is a permanent adhesive graphic with a translucent look, ideal for ghost flames over darker paint. Static cling has no adhesive at all; it clings to smooth paint and can be peeled off and reapplied, which makes it a good choice for temporary displays or testing placement.
Vinyl applies best at moderate temperatures. In cold conditions, work in a garage or warm the surface and the vinyl slightly with a hair dryer so the material stays flexible and the adhesive bonds properly.
12", 18", 24", 36", 48"
Your shopping cart is empty
Notifications
