Skull Flames Half Wrap Decal Set for Cars & Trucks

Description

A skull flames half wrap for cars and trucks, printed on vinyl and sold as a multi-piece set in widths from 12 to 48 inches. Pick your width, trim to fit your panels, and apply it like any large vehicle decal.

Skull Flames Half Wrap Artwork

This half wrap pairs skull graphics with flowing flame extensions, printed with shading and highlights that give the artwork a polished, dimensional look. The design runs along the lower body in a half-wrap layout, leaving the upper panels, roof, and glass untouched so your paint color still shapes the overall look. Because the artwork is printed rather than cut from solid-color vinyl, the shading, highlights, and gradients in the skulls and flames are all part of one continuous print. It is a bold accent for anyone building a skull-themed truck or car who wants more coverage than a small window decal.

Choosing Your Width: 12 to 48 Inches

Every set is offered in widths from 12 inches up to 48 inches, and the width you choose controls the overall scale of the skull flames artwork. Before ordering, measure the panel or body section you plan to cover, from front to rear along the area where the flames will run, and compare that to the listed dimensions at each size option. A smaller width suits doors, quarter panels, or a tailgate accent, while the larger widths are intended for full-length half-wrap coverage along the side of a truck. During installation the vinyl can be trimmed with a sharp blade, so a slightly larger set gives you room to fine-tune the layout.

Solvent-Printed Vinyl With a Detailed Finish

Each piece is solvent printed on vinyl decal stock, the same general construction used for outdoor vehicle graphics. The skull and flame shading are printed into the graphic itself, so the effect is part of the artwork rather than an added layer of material. Because it is a printed graphic rather than real metal, the set stays light and easy to handle. Care is simple: wash with mild soap and water, avoid scrubbing the printed surface, and do not aim a pressure washer directly at the decal edges. Printed in our US-based shop in the width you select.

Applying a Multi-Piece Half Wrap Set

Application follows the same steps as any large vinyl graphic. Wash the panels thoroughly, remove wax or polish from the application area, and let the surface dry completely. Lay the pieces out first to plan the layout across the panel, then apply working from one end, using a squeegee to press the vinyl down and push air out toward the edges as you go. On the wider sizes, a second pair of hands helps keep the vinyl from folding onto itself. If you have never applied graphics this large, a local sign or wrap installer can apply the set for you. Work in moderate temperatures out of direct sunlight for the smoothest results.

What you get

• Skull flames artwork, solvent printed on vinyl
• Multi-piece half-wrap layout for cars and trucks
• Sold in widths from 12 to 48 inches
• Trim-to-fit installation with a sharp blade
• Applies with a squeegee like standard vehicle graphics
• For smooth, clean exterior vehicle surfaces
• Printed in the USA

Specifications

Frequently asked questions

Will this half wrap fit my specific vehicle?

The set is not cut for any particular model. It is sold by overall width from 12 to 48 inches, so measure the area you want to cover and pick the closest size. The vinyl can be trimmed during installation to follow your body lines.

Is the artwork printed or part of the film?

No. The printed artwork is printed artwork that simulates a printed artwork. It is a standard printed vinyl decal, not mirror printed film or plating.

Can I remove the wrap later?

Yes. Warm the decal with a hair dryer or heat gun on a low setting and peel slowly, keeping the heat moving. Take your time on the larger sizes and peel at a steady, shallow angle.